Full coverage adhesive massager
*Product before use 1. Charging (please charge Product before use) 2. Cleaning (clean with water or a neutral detergent such as bath lotion) How to charge 1. Please use the supporting USB charging cable with a power adapter or computer to link
*Please use the national standard 5V (1A or 2A or 4.5A) power adapter for charging
*Cannot charge when the computer is in hibernation
*Gently align the end of the charging USB cable with the charging port and insert it A. Light breathing flashing: charging B. Keep the light on: full C: The invisible charging port is shown below D: After charging, please pull out the end of the charging USB cable gently. Charging precautions
*Please make sure the charger is dry and clean before charging
*Do not expose to high temperature or humidity while charging
*If stored for a long time, please charge it once a month to maintain its charging performance
*There is a rechargeable lithium battery in Product, and the scrap should be treated as scrapped old electronic products and recycled to the corresponding recycling station Remote control mode Remote control button description 1:Product remote control on/off button 1. Long press for 2 seconds to turn on or turn off the remote control. When it is turned on, the remote control is always on white 2: Clitoris vibration button 1. In the power-on state, click the clitoral vibration button, the white light flashes, and the clitoral vibration function 2. Click to cycle through 9 vibration frequencies 3. Long press the clitoral vibration button to turn off this function alone (does not affect other functions) 3: When the host is in standby mode, briefly press the vibration button to start the frequency modulation of the small motor, cycle for 10 frequencies, and press and hold for 1.2 seconds to shut down. 4. There are a total of 10 vibration modes. Small motor button Big motor button This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure statement The device has been evaluatec to meel general RF exposure requirement. The device can be used in porlable exposure condition without restriction.