ECHO CV25 THERMAL FRONT ATTACHMENT Attention!
Export of CV25 models May have export limitations depending on the laws in your region. Attention!
The proper usage of the device is important for safe exploitation!
Therefore read carefully the present manual!
If the device was left in storage for a longer period of time, before exploitation check its funtionality. Disassembling of the device is prohibited,except in authorized repair centers. 1 The external optical surfaces should be clean at all times.Touching the optical surfaces with bare hands is not recommended. Sand and sea water can damage the optical coatings!
Do not point the device directly at the sun!
Image performance is dependent on scenery and atmosphere conditions. Contrast in the same image may vary as a function of the time of day due to the effect of the sun.For example,at sunset objects will have absorbed different levels of heat resulting in greater temperature differences and better contrast. When left in storage for a longer period of time,batteries have to be removed and stored in polyethylene bags to prevent contact with metal.(It is recommended to recharge the batteries every two to three months) When carrying or transporting the device,put the protective lens cap!
Condensation can cause fogging of the optical surfaces! Condensation occurs when the temperature or humidity changes as follows:
When moving the device from cold to warm place or vice versa;
In places with high humidity. When equalizing the temperature of the device with the environmental, the condensation disappears.Use the towel to remove moistu Clean the lens surfaces with the Lens Cloth or with the napkin!
LEGAL NOTIOE Before attaching to weapons,check the regional legal regulations in the area of application. The attachment to a weapon is always the sole responsibility of the user. Quick Menu The Quick menu allows change of basic settings. Take Photo Short press Right button to take a photo. Start/Stop Video Recording Long press Right button to start/stop video recording. NUC Short press Up button to do Manual Non-uniformity calibration. Main Menu Long Press Up Button to enter/exit Main menu. Left Gama Long press Down button to switch open or close Gama 1 Power off Long press Middle button to power off the device Take Photo/Video on-boarding Short Press Right button to take a photo Please note the following before using You can not take photos/videos while connecting with PC.Otherwise the photos/videos are not actually saved. And Photos/videos can only be taken when WiFi is on When you take photos, do not press too quickly. How to replay on PC?
Connect the Type-C usb cable to PC. 2 Main Menu Long press Up button to enter main menu. Short press Right button to move the cursor from 1 to 8, short press Left button to move the cursor from 8 to 1. 1) Screen Brightness 2) Image Mode 3) Palette 4) WiFi 5) Advance Setting 6) Microphone 7) Alignment 8) NUC 4 Screen Brightness Short press Center button enter screen bright modeShort press Right/Left button to change Screen Brightness from 1~9. When the brightness is adjusted to 9or 1, change the setting according to the narrow points. Long press Right button to exit screen bright mode. Image Mode (standby) Short press Center button enter image mode, Short press Right/Left button to turn on/off standby;
If the standby mode is turned on, the button will enter the standby mode after no operation for 2 minutes Long press Right button to exit image mode;
Palette Short press Center button enter palette mode, Short press Right/Left button to switch the Palette from WH-BH;
Long press Right button to exit palette mode;
WiFi Short press Center button enter wi mode, Short press Right/Left button to turn on/off WiFi, the default status is WiFi off. With shown in display means WiFi is on, without shown in display means WiFi is Off. Long press Right button to exit wi mode;
Advance Setting Short press Center button to enter submenu of Advance Setting. Long press Right button to exit submenu of Advance Setting. Short press Down button to move the cursor from 0 to M, short press Left button to move the cursor from M to 0. Short press center button to enter menu ;
Short press Right/Left to to change the parameter value;
long press Right button to exit menu;
0)Device info :Device version number;
1)Contrast :Contrast parameters grade 0-9;
2)Sharp grade :sharp grade 0-14;
3)Sharp : sharp on/off;
4)Light bright : light parameters grade 0-9 5 5)3D : 3D denoise on/off;
6)2D grade : 2D denoising grade 0-7;
7)2D : 2D denoise on/off;
8)Med grade: median lter grade 0-6;
9)Defective pixel repair : short press Right to clear bad point ,short press Left to save bad point data ;
M)magnication: Detail separation grade :1-6;
microphone Short press Center button enter microphone mode, Short press Right/Left button to turn on/off microphone;
Long press Right button to exit microphone mode;
Alignment Short press Center button enter alignment mode, adjusted with accuracy 0.1 mrad before shipping out. The nal accuracy depends on users rifle scope, parallax and shooting distance.super accuracy by alignment. Operating Instructions for accuracy correction:
1) Aiming your daytime scope to the middle of target and shoot which is to test and control good daytime scope accuracy. 2) Clip on to the daytime scope by adapter. Aim to the thermal target and shoot again. 3) Measure horizontal distance x and vertical distance y between shooting position and target from step 2. 4) Short press Center button to enter Alignment. 5) Short press Right button to adjust the value of y, short press Up/Downto adjust the value of x. Calibration Short press Center button enter calibration mode ,Short press Left/Right button to switch A/M/S mode;
Long press Left button to exit calibration mode;
6 Storage and Transportation Before storing it, clean obligatory the device
(if on its surface there are moisture, dust or traces of dirt)!
Make sure that there are no traces of moisture, and the battery compartment is empty!
It is also possible for a short periods of time device to be stored in a suitable soft pack, bag or cartridge box. The premises in which the device is kept for long term have to be dry, enclosed, unheated and ventilated. During the storage should not be allowed exposure to aggressive environments, temperatures below -50C and above +60C, relative humidity greater than 80%, and prolonged periods of direct sunlight. Before each transportation, the product should be neatly packed in its original packaging
(transport bag) and all other items and accessories should be carefully and steadily placed in the bag. After that the bag should be steadily placed in the transport suitcase. You can ship the product with all types of transport at different distances and at altitude up to 12000 m. 7 CV25 Specification CV 25 Uncooled Vox 640x512 50Hz 12m 8-14m 20mk 25mm 1.55X 18.414 3m 2 Yes 32G OLED 1024768 118650 5V Type-C 6.5h 500g 1277658mm IP67
-20
-50
-40
-60 Detector Type Resolution Frame rate Pixel Spectral range NETD Optical Characteristics Objective lens Magnification FOV(HV), m@100m Close-up range Functions Palettes WIFI Storage capacity Display Type Resolution Power Supply Battery External power supply Operating time (at t=22C) Physical Characteristics Weight without battery Dimension Environmental Compatibility Ingress protection rating Operating temperature Storage temperature 8