RGB LED Controller Instrustions You can use the switch or remote to control the lighting effects. Description of switch function light strip for bar table 1.Power onloff-Press and hold the power button. 2.Change the mode:Short press the cycle button.(Multiple mode options:Static Red/Static Green/Static Blue/Static White/Multicolor Change/Multicolor Flash/Multicolor Breathing/White Breathing/Red Breathing/Green Breathing/Blue Breathing) 3.Adjust the flashing speed:Short press the power button. 4.Adjust the brightness Press and hold the cycle button and short press the power button meanwhile. Remote control instructions Next mode Previous mode Pre mode NOTE 1. During use, if the switch can work normally, but the remote control cannot, you need to perform the code matching operation. 2.if the light is interfered by other remote controls or cannot be controlled remotely. Please power off and then power on again before performing code matching. How to perform code matching operation: Press and hold the start button on the remote control for 3 seconds within 7seconds of turning on the power, the light strip flashes 3 times with white light, indicating that the code (remote control) is matched. FCC ID: 2A9H8-LBT020 IC: 30943-LBT020 to and cause harmful frequency will to the occur or is equipment part harmful radio FCC Statement has This 15 pursuant against interference radiate may not interference radio interference on, off user following measures:
Reorient Increase Connect connected. Consult Caution:
void could device This conditions:
any the Any your complies
(1) relocate the separation equipment or dealer changes interference or the the This the with designed limits to a for provide been the of found These residential tested FCC in energy interference a television encouraged and Rules. a and, to particular reception, try not if radio to in comply are to limits installation. and installed communications. If be the installation. which can correct to This used B and digital Class reasonable device, protection uses can instructions, that harmful equipment the generates, the guarantee cause the or with is no does turning one by more of accordance there equipment equipment in However, this determined interference by receivingantenna. between an into the outlet on equipment and a circuit receiver. different from that to which the receiver is experienced an modications or this authority to the with of cause device received, interference operate part 15 may not including radio/TV to this equipment. Rules. FCC harmful that technician not device help. for explicitly approved by manufacturer Operation interference, cause may subject is and undesired to this the device operation.
(2) following must two accept RF The in Exposure device portable Information has been exposure evaluated condition to meet without general RF restriction. exposure requirement. The device can be used ISED Statement English:This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B). French: Cet appareil contient des metteurs/rcepteurs exempts de licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et Dveloppement conomique Canada. L'exploitation est soumise aux deux conditions suivantes :
(1) Cet appareil ne doit pas provoquer d'interfrences.
(2) Cet appareil doit accepter toute interfrence, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de l'appareil. l'appareil numrique du ciem conforme canadien peut - 3 (b) / nmb - 3 (b). This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. cet appareil est conforme l'exemption des limites d'valuation courante dans la section 2.5 du cnr - 102 et conformit avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des donnes canadiennes sur l'exposition aux champs rf et la conformit. This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. Cet quipement est conforme aux limites d'exposition aux rayonnements du Canada tablies pour un environnement non contrl. The device has been evaluated to meet general RF exposure requirement. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body. L'appareil a t valu pour rpondre aux exigences gnrales d'exposition aux RF. Cet quipement doit tre install et utilis avec une distance minimale de 0 mm entre le radiateur et votre corps.