Honeywell, Inc. ADEMCO 5802CP BELT CLIP TRANSMITTER INSTALLATION AND SETUP GUIDE Programming The Serial Number:
The 5802CP has a unique identification code
(serial number) permanently assigned during manufacture. You must enroll the transmitters serial number into the control panel. All 5802CP transmitters shall be programmed as BR type units (i.e., unsupervised Button RF). Note: During the enrollment procedure, two transmissions must be sent (by pressing the button). Allow at least 8-seconds between transmissions. See the control panels Installation and Setup Guide for further details regarding possible zone responses and programming. About The 5802CP:
The ADEMCO 5802CP is a belt clip style Emergency wireless transmitter that may be worn on a belt or carried in a pocket or purse. Pressing the button on the transmitter (for at least one second) will send an alarm signal to the control receiver. The 5802CP is intended for use only with wireless alarm systems that support 5800 series devices. The control receivers response to the 5802CP signal can be set for either 24-hour audible alarm or 24-hour silent alarm by appropriate programming of the control receiver. The 5802CP is powered by a non replaceable Lithium battery designed to provide long life. The entire 5802CP should be replaced when a low battery condition is indicated by the control unit. FCC ID: CFS8DL5802CP-1 FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. IC: 573F-5802CP1 Specifications Unit Dimensions: 2-5/8 (67mm) x 1-1/2 (38mm) x 1 (25.4mm) LED: Lights when unit transmits. REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.