Quick Installation Guide This wireless door / window sensor is intended for use with controls that support SiX series devices. Magnet Gap: Wood = 1.375 in. (34.93mm) Steel = 0.625 in. (15.86mm) SiXMINICTA Wireless Door/Window Contact | Contact de porte / fentre sans fil | Contacto inalmbrico de puerta / ventana Guide d'installation rapide Ce contact de porte / fentre sans fil est conu pour tre utilis avec les panneaux de commande qui supportent les dispositifs de la srie SIXMC. Gua Rpida de Instalacin Este sensor inalmbrico para puerta / ventana, ha sido diseado para usarse con los controles compatibles con los dispositivos de la serie SiX. cart de l'aimant : Bois = 1,375 po (34.93mm) Acier = 0.625 po (15.86mm) Espacio del imn: Madera = 1.375 in. (34.93mm) Acero = 0.625 in. (15.86mm) Enroll To enroll the device, use the programming app. When prompted, activate the device by pulling the battery tab (use the Magnet if the battery tab is removed). After enrolling, verify adequate signal strength by conducting a Walk tests (see the controllers instructions) with the device in its intended mounting location. Adjust the device location and orientation as necessary. Once enrolled, the device cannot be used with another system until it is removed from the current controller. See the controllers instructions. Enrlement Utilisez l'application de programmation pour enregistrer un dispositif. Lorsque lidentifiant vous est demand, activez le dispositif en tirant sur la languette de la pile (Utilisez l'aimant si la languette de la batterie est retire).. Aprs l'enrlement, vrifiez la puissance du signal adquate en effectuant des test Marche (voir les instructions du panneau de commande) avec le dispositif dans son emplacement de montage prvu. Au besoin, modifiez l'emplacement ou l'orientation du dispositif. Une fois enrl, le dispositif ne peut pas tre utilis avec un autre systme avant d'avoir t supprim du panneau actuel. Reportez-
vous aux instructions du panneau. Enrolar Para inscribir el dispositivo, use la aplicacin de programacin. Cuando se le solicite la identificacin, active el dispositivo tirando de la lengeta de la batera (use el imn si la lengeta de la batera ha sido removida). Una vez registrado, verifique la intensidad de seal adecuada realizando prueba Caminar (ver las instrucciones del controlador) con el dispositivo en la ubicacin deseada. Ajuste la ubicacin y orientacin del dispositivo segn sea necesario. Una vez registrado, el dispositivo no se puede usar con otro sistema hasta que sea removido del controlador actual. Ver las instrucciones del controlador. BATTERY CAUTION: Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212F (100C) or incinerate. Dispose of used batteries properly. Keep away from children. NOTE: Constant exposure to high or low temperature or high humidity may reduce battery life. Attention de batterie: Risque d'incendie, d'explosion et de brlures. Ne rechargez pas, dmonter, chauffer au-dessus de 212F (100C), ou incinrer. Dbarrassez-vous des batteries utilises de faon approprie. Gardez partir des enfants. NOTE : Une exposition constante des tempratures leves ou basses ou un taux d'humidit leve peut rduire la dure de vie de la pile. Precauciones con respecto a las bateras: Riesgo de FUEGO, explosin y quemaduras. No recargar, desarmar, calentar por encima de 100C
(212F), o incinerar. Descarte Apropiadamente las bateras usadas. Mantngalas fuera del alcance de los nios. NOTA: Exposicin constante a altas o bajas temperaturas o alta humedad puede reducir la vida til de la batera. FEDERAL COMMUNICATIONS COMMISSION (FCC) & INDUSTRY CANADA (IC) STATEMENTS The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment. CLASS B DIGITAL DEVICE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, as defined by FCC Rules Part 15.105. The Class B Digital Device statement can be viewed at: https://customer.resideo.com/en-US/support/residential/codes-and-standards/FCC15105/Pages/default.aspx FCC / IC STATEMENT This device complies with Part 15 of the FCC Rules, and Industry Canadas license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Cet appareil est conforme la partie 15 des rgles de la FCC et exempt de licence RSS dIndustrie Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer dinterfrences nuisibles. (2) Cet appareil doit accepter toute interfrence reue y compris les interfrences causant une rception indsirable. Responsible Party / Issuer of Suppliers Declaration of Conformity: Ademco Inc., a subsidiary of Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Ph: 516-577-2000 Partie responsable / metteur de la dclaration de conformit du fournisseur : Ademco Inc., une filiale de Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Tl. 516 577-2000 Parte responsable / Emisor de la Declaracin de conformidad del proveedor: Ademco Inc., una subsidiaria de Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Ph: 516-577-2000 RF EXPOSURE Warning The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 7.8 in (20 cm) from all persons and must not be co-located or operated in conjunction with any other transmitter except in accordance with FCC and ISED multi-transmitter product procedures. Mise en Garde Exposition aux Frquences Radio: La/les antenne(s) utilise(s) pour cet metteur doit/doivent tre installe(s) une distance de sparation d'au moins 20 cm (7,8 pouces) de toute personne et ne pas tre situe(s) ni fonctionner paralllement tout autre transmetteur ou antenne, except en conformit avec les procdures de produit multi transmetteur FCC et ISED. DECLARACIN IFETEL La operacin de este equipo est sujeta a las siguientes dos condiciones 1. Es posible que este equipo o dispositivo no cause interferencia perjudicial y 2. Este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operacin no deseada. Replace Battery / Remplacement des piles /
Cambiar batera For Technical Support, call 1-877-748-7628, option 3 For documentation, call Customer Service at:
1-800-238-2727 (1-800-ADT-ASAP). Pour le support technique, appelez 1-877-748-7628, option 3. Pour la documentation, appelez le service clientle au 1-800-238-2727 (1-800-ADT-ASAP). Para soporte tcnico, llame al 1-877-748-7628, opcin 3 Para documentacin, llame a Servicio al Cliente a:
1-800-238-2727 (1-800-ADT-ASAP). U.S. warranty / U.S. garantie / U.S. garantie https://www.security.honeywellhome.com/hsc/resources/wa/index.html Patents / Brevets / Patentes https://www.resideo.com/patent Specifications / Spcifications / Especificaciones:
Battery / Pile / Batera: 1 x 3V,Coincell; Honeywell BL3-0004 (CR2450); Duracell DL2450;
Panasonic CR2450; Energizer CR2450 Tamper / Interrupteurs antisabotage / Manipulacin: Cove / Couvercle / Tapa / Tampa RF Frequency / Frquence RF / Frecuencia de RF: 2.4GHz Operating Temperature / Temprature de fonctionnement / Temperatura de funcionamiento: 32 122F /
0 50C (Agency Compliance 32 120F / 0 49C) Relative Humidity / Humidit relative / Humedad relativa: 95% max. (Agency Compliance - 93% max.), non-
condensing / sans condensation / sin-condensacin / sem condensao Dimensions / Dimensions / Dimensiones: 0.45H x 1.25W x 2.44L
(11.5mm H x 32mm W x 62mm L) REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM. Product must be tested at least once each year POUR LES LIMITES DU SYSTME DALARME AU COMPLET, REPORTEZ-VOUS AU GUIDE DINSTALLATION DU PANNEAU DE COMMANDE. Le fonctionnement du produit doit tre vrifi au moins une fois par anne CONSULTE LAS INSTRUCCIONES DE INSTALACIN PARA EL CONTROLADOR CON EL CUAL SE UTILIZA ESTE DISPOSITIVO, PARA OBTENER DETALLES CON RESPECTO A LAS LIMITACIONES DE TODO EL SISTEMA DE ALARMA. El producto debe ser probado al menos una vez al ao Approval Listings /
Approbations Homologations / Listas de aprobaciones /
Listagens de aprovao:
FCC / IC ETL Listed to UL 634 cETL Listed to ULC/ORD-C634 Other Standards: RoHS ADT Security Services Boca Raton, FL 33431 1501 Yamato Rd 800-21715-13 SiXMINICTA 800-21715-1 6/18 Rev C