User Manual
AMIS-850
AMIS-EMXXXXXXX-XXX
AMIS-850 User Manual
ii
Copyright
The documentation and the software included with this product are copyrighted 2019
by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right
to make improvements in the products described in this manual at any time without
notice. No part of this manual may be reproduced, copied, translated or transmitted
in any form or by any means without the prior written permission of Advantech Co.,
Ltd. Information provided in this manual is intended to be accurate and reliable. How-
ever, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringe-
ments of the rights of third parties, which may result from its use.
Acknowledgements
Intel and Pentium are trademarks of Intel Corporation.
Microsoft Windows and MS-DOS are registered trademarks of Microsoft Corp.
All other product names or trademarks are properties of their respective owners.
Instructions for the User
The document combines text and illustrations, providing a comprehensive overview
of the system. The information is presented as a sequential step of actions, allowing
the user to learn directly how to use the device.
The text provides explanations and instructs the user step-by-step in the practical use
of the product, with short, clear instructions in an easy-to-follow sequence.
AMIS-850 User Manual
iii
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Radiation Exposure Statement:
For body worn operation, this device has been tested and meets FCC RF exposure guidelines.
When used with an accessory that contains metal may not ensure compliance with FCC RF
exposure guidelines.
AMIS-850 User Manual
iv
Warnings, Cautions and Notes
Warning! A WARNING statement provides important information about a poten-
tially hazardous situation which, if not avoided, could result in death or
serious injury.
Caution! A CAUTION statement provides important information about a poten-
tially hazardous situation which, if not avoided, may result in minor or
moderate injury to the user or patient or in damage to the equipment or
other property. Please contact a qualified technician or your retail
provider for it replacement. Do not do it by yourself.
Note!
A NOTE provides additional information intended to avoid inconve-
niences.
Within the European Union
EU-wide legislation, as implemented in each Member State, requires that
waste electrical and electronic products carrying the mark (left)
must be disposed of separately from normal household waste.
This includes monitors and electrical accessories, such as signal
cables or power cords. When you need to dispose of your
display products, please EU-wide legislation, as implemented in
each Member State, requires that waste electrical and electronic
products carrying the mark (left) must be disposed of separately
from normal household waste. This includes monitors and
electrical accessories, such as signal cables or power cords. When
you need to dispose of your display products, please follow the
guidance of your local authority, or ask the shop where you
purchased the product, or if applicable, follow any agreements
made between yourself.
Part No.
Printed in Taiwan
Edition 1
Apr 2021
AMIS-850 User Manual
v
Product Warranty
WHAT'S COVERED & HOW LONG
Standard warranty covers two (2) - years structural components, two (2) - years for
the system and electronics.
Warranty coverage begins on product's date of delivery. Standard warranty does
not cover problem resulting from product abuse, negligence/accident, misuse,
improper operation, post-delivery physical damage, and/or product modifica-
tions without Advantech's prior written approval.
External peripherals (including: computing equipment/devices, monitors,
key- boards, mouse, are not included in this warranty.
Advantech shall not be liable for any consequential or incidental damages.
HOW WE HELP YOU
Support services provided along with the standard warranty must be requested within
the expressed warranty time frame for the product element.
Technical support may request customer collaboration and assistance during
diagnosis to provide for the next business day service resolution. Typically, this
requires, but is not limited to:
Identifying a primary contact representative (with phone number and e-
mail address) to work with Advantech and answer relevant questions.
Providing the serial ID number and access to the product.
Performing basic troubleshooting activities as directed by Advantech Technical
Support.
Resolution methods can include, but are not limited to, any of the following:
Verbal/written instructions to correct the problem.
On-site dispatch of an Advantech authorized service technician.
Shipping of replacement parts.
If needed, Advantech will involve its design engineers or supplier partners for resolu-
tion assistance and customer's satisfaction. Determination for resolving warranty
issues will be at Advantech's sole discretion.
AMIS-850 User Manual
vi
Safety Instructions
1.
Strictly follow these instructions for use; please read these safety
instructions carefully.
2. Keep this user manual for later reference; any use of the product requires
full understanding and strict observation of all portions of these instructions.
Observe all.
3. Repair of the device may also only be carried out by trained service personnel.
4. Advantech recommends that a service contract be obtained with Advantech
Service and that all repairs also be carried out by them. Otherwise the
correct functioning of the device may be compromised.
Warning! Because of the danger of electric shock, never remove the box of a
device while it is in operation or connected to a power outlet.
5.
If one of the following situations arises, get the equipment checked by
service personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according
to the user manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
6. Disconnect this equipment from any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents for cleaning and keep this equip-
ment away from humidity.
Caution! To avoid short-circuits and otherwise damaging the device, do not allow
fluids to come in contact with the device. If fluids are accidentally spilled
on the equipment, remove the affected unit from service as soon as pos-
sible and contact service personnel to verify that patient safety is not
compromised.
7. Put this equipment on a reliable surface during installation. Dropping it or
letting it fall may cause damage. For plug-in equipment, the power outlet
socket must be located near the equipment and must be easily accessible.
Caution! Do not leave this equipment in an uncontrolled environment where the
Storage temperature is below 0° C or above 50° C. This may damage the
equipment.
8. Grounding reliability can only be achieved when the equipment is connected
to an equivalent receptacle marked “Hospital Only” or “Hospital Grade”.
9. Use a power cord that matches the voltage of the power outlet, which has
been approved and complies with the safety standard of your particular
country.
If the integrity of the protective earth conductor is in doubt. Please turn off
10.
AMIS-850 User Manual
vii
the power switch.
11. To disconnect this product from the mains supply disconnects the mains plug
from the socket outlet. The power supply is regarded as part of this
equipment.
12. Make sure user not to contact SIP/SOPs and the patient at the same time.
13. Do not switch on/off the power switch of the battery system during operation.
Warning! To avoid risk of electric shock, this equipment must only be connected to a
supply mains with protective earth.
Warning! No modification of this equipment is allowed.
14. The power cord for use on the device shall be no less robust than
ordinary tough rubber sheathed flexible cord (IEC 60245-1:2003, Annex
A, designation
53) or ordinary polyvinyl chloride sheathed flexible cord (IEC 60227-1:1993,
Annex A, design. 53. For the US/CA the requirements of the NEC and
Canadian code shall be followed (US and CA national differences).
Warning! Battery system, equipotential pin, metal wiring on equipotential pin,
wheels and brake shall be replaced/send back to maintain by the manu-
facturer every two years, risks of function failure, electrical shock, equip-
ment damage, environment pollution and etc. may occur if not doing so.
15.
If your computer clock is unable to keep accurate time or the BIOS
configuration resets to default, please check the battery.
Caution! Do not replace the battery yourself. Please contact a qualified technician or
your retailer.
The computer is provided with a battery-powered real-time clock circuit.
There is a danger of explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer's instructions.
Caution! When servicing the device, always use replacement parts that meet
Advantech standards. Advantech Medical cannot warrant or endorse the
safe performance of third-party replacement parts for use with our
medical device.
Caution! Application User: This device is provided to professional
nurses/caregivers and technicians. Cannot be used by people other than
nurses/caregivers and technicians
16. CLASSIFICATION:
Supply Class I adapter
No applied part
AMIS-850 User Manual
vii
Continuous Operation
AMIS-850 User Manual
ix
Safety Information
For your own safety and that of your equipment, always take the following precau-
tions.
Disconnect the power plug (by pulling the plug, not the cord), from your computer if
any of the following conditions exists:
The power cord or plug becomes frayed or otherwise damaged
Your eMedication box has been damaged
You suspect that your computer needs service or repair
You want to clean the eMedication box
You want to remove/install any parts
GROUNDING
SERVICE AND REPLACEMENT
Connect the AMiS eMedication box to an equivalent receptacle marked "Grounding
material" to ensure ground.
Do not attempt to service or replace any part of the AMiS eMedication box unless
directed to do through Advantech approved documentation (i.e., this User Manual or
other instructions). Only Advantech or an Advantech certified entity may service or
replace the cart components. If any component on the cart is missing or damaged,
the cart must not be used. Contact Advantech immediately to request service. The
non-detachable power cord is not intended to be replaced by anyone except for
Advantech approved professionals, the power cord can only be the ones that matches
the voltage of the power outlet, as well as been approved and complies with the safety
standard of your particular country.
DO NOT OPEN THE POWER SYSTEM
Unauthorized personnel opening the power system may cause injury and/or death. If
the unit is not working properly, please contact Advantech.
We are not allowing customer to swap battery pack or cells, if we find the power sys-
tem be opened/disassembly by customer, Advantech will not guaranty the power sys-
tem warranty from then on.
DO NOT USE THE UNIT IN OR NEAR WATER OR OTHER LIQUIDS
If the unit becomes wet, unplug it immediately, wipe away any excess liquid and allow
it to dry before use.
Failure to do so can result in injury and/or death.
DO NOT MOVE THE EQUIPMENT WHEN THERE IS PEOPLE AROUND
If there are people around the equipment, in order to avoid people’s hands stuck on
the iron bars, do not move the equipment.
Failure to do so may cause harm to people’s hands.
AMIS-850 User Manual
x
Additional Information and Assistance
1. Visit the Advantech website at http://support.advantech.com where
you can find the latest information about the product.
2. Contact your distributor, sales representative, or Advantech's
customer service center for technical support if you need additional
assistance. Please have the following information ready before you
call:
– Product name and serial number
– Description of your peripheral attachments
software, etc.)
– A complete description of the problem
– The exact wording of any error messages
– Description of your software (operating system, version, application
– This equipment is a source of electromagnetic waves. Before use
please make sure that there are not EMI sensitive devices in its
surrounding which may otherwise malfunction
Environmental Protection
Follow national requirements to dispose of unit.
AMIS-850 User Manual
xi
AMiS-850 User manual
Item
AMiS-850 outlook
Manual unlock function
DC-12V power adapter and cable
Electronic control function USB cable
Mounting design
1.AMiS-850 Outlook
s
manual unlock key
AMIS-850 User Manual
xii
2. Manual unlock function
Power cable and control USB cable.
insert key into the key hole. Turn the key clockwise to
release all the bins.
3. DC-12V power adapter and cable
Power on function: using a DC-12V adapter to connect the medication box.
Connection function : Using USB cable to connect with medication box, and check
device manager has COM port device.
AMIS-850 User Manual
xii
4.Electronic control function USB cable
Route \app\bin\AdvMediBoxDemo_SW
Select AMiS-850
Check error message come out or not.
AMIS-850 User Manual
xiv
Close 16 bin, and select open all to open all the bins.
xv
AMIS-850 User Manual
Close 16 bin, and select bin ID to check all the bins ID.
Firmware version checking
Hardware→Firmware version, will show all the PCB FW information.
AMIS-850 User Manual
xv
AMIS-850 User Manual
xv
5. Mounting design
Basic mounting description
medication box din rail
Mounting bracket, put the bracket into the
slide in and watch the cable routing.
after slide in, screw on these two screw
to fix the bracket.
AMIS-850 User Manual
xv
How to mount medication box on cart.
Screw on bracket on cart.
slide in the medication box.
AMIS-850 User Manual
xix