User Manual VingCard DLC2 FCC (Federal Communications Commission) statements This device comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) The product LCX 7302 may not cause harmful interference, and 2) The product LCX 7302 must accept any interference received, including interference that may cause undesired operation. Important note: To maintain compliance with FCCs RF exposure guidelines, this equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. Use only the supplied antenna. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antennas or transmitters. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio freq uency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. 2 66 5013 158-0 IC (Industry Canada) statements This device comply with Industry Canada licence-exempt RSS standard CAN ICES-3 (B)/NMB-3(B) B. Operation is subject to the following two conditions:
1) The product LCX 7302 may not cause interference, and 2) The product LCX 7302 must accept any interference, including interference that may cause undesired operation of the device . Important note: To comply with Industry Canada RF radiation exposure limits for general population, the antennas used for these transmitters are exempted from Routine Evaluation Limits SAR Evaluation in accordance with RSS-102 section 2.5.1. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. The product LCX 7302 IC: 9514A-LCX7302C1 has been approved by Industry Canada to operate with the antenna type listed below with the indicated maximum permissible gain and required antenna impedance. Antenna types not included in this list, having a gain greater than the maximum gain indicated fo r that type, are strictly prohibited for use with this device. Name/Model F-antenna Gain
-5 dBi Impedance 50 ohm The term "IC" before the equipment certification number only signifies that the Industry Canada technical specifications were met. Dclarations dIndustry Canada Cet quipement est conforme aux normes dexemption de licence RSS dIndustry Canada CAN ICES-3 (B)/NMB-3(B) B. Son utilisation est soumise aux deux conditions suivantes:
1) Le produit LCX 7302 ne doit pas provoquer dinterfrence, et 2) Le produit LCX 7302 doit accepter toute interfrence, y compris des interfrences susceptibles de provoquer un fonctionnement indsirable de lquipement. Remarque importante: Pour respecter les limites dexposition aux radiofrquences dIndustry Canada pour le grand public, les antennes utilises pour ces metteurs-transmetteurs sont exemptes des limites dvaluation de routine valuation SAR, conformment la norme RSS-102 section 2.5.1. Conformment aux rglementations dIndustry Canada, cet metteur radio peut uniquement fonctionner laide dune antenne don t le type et le gain maximal (ou minimal) pour ces metteurs-transmetteurs sont approuvs par Industry Canada. Pour rduire le risque d'interfrence ventuelle pour les autres utilisateu rs, le type et le gain de l'antenne doivent tre choisis de manire ce que la puissance isotrope rayonne quivalente (p.i.r.e.) ne soit pas suprieure la puissance ncessaire une bonne communication. Ce produit LCX 7302 IC: 9514A-LCX7302C1 a t approuv par Industry Canada pour une utilisation avec les types dantenne indiqus ci-dessous avec le gain maximum autoris indiqu et limpdance dantenne requise. Il est strictement interdit dutiliser avec cet appareil un type dantenne ne figurant pas dans cette liste ou ayant un gain suprieur au gain maximum indiqu pour ce type. Appellation/Modle Antenne Gain
-5 dBi Impdance 50 ohm Le terme IC devant le numro de certification de lquipement signifie seulement que les spcifications techniques dIndu stry Canada ont t respectes. 3 66 5013 158-0 Successful opening Find your room. Touch the handle (green light). Enter the room. Unsuccessful opening Find your room. Touch the handle (red light). Contact the reception. 4 66 5013 158-0 5 66 5013 158-0