Quick Reference Guide DRAFT ZigBee Gateway 1 Copyrights The information in this document is subject to change at the sole discretion of ASSA ABLOY AB without notice. Any use, operation or repair in contravention of this document is at your own risk. ASSA ABLOY AB does not assume any responsibility for incidental or consequential damages arising from the use of this manual. All information and drawings in this document are the property of ASSA ABLOY AB. Unauthorized use and reproduction is prohibited. VingCard is a registered trademark of ASSA ABLOY AB. 2 Table of contents FCC and IC statements
..................................................................................................................... 4 FCC statements IC statements Gateway dimensions
.............................................................................................................................................. 4
.............................................................................................................................................. 4
..................................................................................................................... 6 Quick reference of technical data
..................................................................................................................... 7 To mount a gateway
..................................................................................................................... 8 3 FCC and IC statements FCC (Federal Communications Commission) statements This device comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Important note: To maintain compliance with FCCs RF exposure guidelines, this equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. Use only the supplied antenna. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antennas or transmitters. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The concerned end product must be labeled to say 'FCC ID: Y7V-GW683081066'. IC (Industry Canada) statements This device comply with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conform aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Important note: To comply with Industry Canada RF radiation exposure limits for general population, the antennas used for these transmitters must be installed such that a minimum separation distance of 20 cm is maintained between the radiator (antenna) and all persons at all times and must not be co-located or operating in conjunction with any other antenna or transmitter. 4 DRAFT 66 3081 060-0 Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication. This radio transmitter IC9514A-GW683081066 has been approved by Industry Canada to operate with the antenna type listed below with the indicated maximum permissible gain and required antenna impedance. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Name/Model Inverted F-antenna Gain 3.5 dBi Impedance 50 ohm The term "IC" before the equipment certification number only signifies that the Industry Canada technical specifications were met. Le terme "IC" devant le numro de certification signifie seulement que les specifications techniques Industrie Canada ont t respectes. 5 DRAFT 66 3081 060-0 Gateway dimensions Figure 1 6 DRAFT 66 3081 060-0 Quick reference of technical data Note: For more information about the gateway (e.g. about web interface, reset, boot-up, commissioning the gateway in a ZigBee system etc), see User manual Online option. Figure 2 Automatic adjustment to 10 or 100 Mbit/s networks Powered via Ethernet or by a power adapter (5VDC) Note: The gateway is of PoE class 1; power range 0.44-3.84W. Low power consumption The total number of gateways is virtually unlimited Can have either five routers or 15 endnodes connected Case with the dimensions 63,0 mm x 144,0 mm x 27,5 mm
(2 31/64" x 5 43/64" x 1 3/32") Easy mounting (can be mounted either with adhesive VELCRO strips or fastening screws; a package with two VELCRO strips and two fastenings screws are enclosed) Weight: 116 g Flame retardant ABS UL94 V-0 approved Colour: RAL 7047 Suitable for operation in the range 5-50 C and 10-90%
non-condensed relative humidity 7 DRAFT 66 3081 060-0 To mount a gateway Preferred way of mounting the gateway is horizontally:
Figure 3 8 DRAFT 66 3081 060-0 Asia / Pacific:
E-mail: apac@vingcardelsafe.com Phone: +65 6305 7670 Europe / Middle East / Africa:
E-mail: emea@vingcardelsafe.com Phone: +47 69 24 50 00 Latin America:
E-mail: lam@vingcardelsafe.com Phone: +52 55 36 40 12 00 North America:
E-mail: northamerica@vingcardelsafe.com Phone: +1 972 907 2273 ASSA ABLOY Hospitality P.O. Box 340 1402 Ski Norway Phone: +47 69 24 50 00 info@vingcardelsafe.com | www.vingcardelsafe.com Provider of: VingCard Locks & Systems | Elsafe Safes | Orion EMS | PolarBar Minibars Specifications may change without notice 9