PART 3. USING THE ATW-T102 PLUG ON TRANSMITTER The plug on transmitter operates on ane 9V battery. Please make sure that your batteries are fresh. We recommend that you use Alkaline batteries and that you aveid using NiCad if possible. Insert the batteries inte the battery compartment and gently slide the battery cover back into place. To set the channel of operation, locate the X1 and X14 channel selector switches. Set the switches tot he to the corresponding channel as set on the receiver, Replace the cover over the rotary switches. Connect a hardwire microphone to the XLR connector and lock the microphone into place by screwing the locking mechanism into place. Tum the transmitter switch to the on position. Confirm that the receiver is receiving RF. Speak directly into the microphone and confirm that audio is passing through the receiver. You are now s to use the system. PART 4. USING THE ATW-R1M RECEIVER The ATW-RIO0 diversity receiver operates intemally on two 9' batteries of can be operated via the an external 12 power pack... Push the Ext.\Offlnt. switch to the appropriate position . Check the group and channel setting to confirm that they correspond to the settings of the transmitter. Connect the balanced or audio output to your mixer or camera audio input, Adjust the volume setting to the desired level. Speak into the microphone and listen to the audio cut at the speaker. If satisfied with the audio quality , you can use the system. its use subject to certain FOC and other regulatory agency restrictions and licensing requirements. For further information, please contact your local office of the FICC as applicable. PART 2. USING THE ATW-101 BELTPACK TRANSMITTER The beltpack transmitter operates ona JV battery. Please make sure that your batteries are fresh. We recommend that you use Alkaline batteries and that you avoid using NiCad if possible. Insert the batteries into the battery compartment and slide the battery compartment back inte place. Open the battery compartment and locate the channel selector switches. Set the X1 and X10 channels to the comesponding channel as set on the receiver. Connect your microphone to the connector on the top side of the transmitter. Tur the transmitter switch to the on position, Confirm that the receiver is receiving RP and that audio is passing through he receiver. You are mow set to use the system,