for iPad Mini1, Mini 2 & Mini 3 Getting Started Attach 1) Choose Choose from either the black or white shims. 2) Insert 3) Test Remove the tape and insert the shims into the hinges. Note: Ensure the rubber foot push through the heel of the hinge. Ensure both hinges are aligned, insert your iPad then remove it to make sure your iPad is held securely. 4) Adjust To get the right fit, remove the iPad and gently squeeze the hinge. Note: Repeat this process until the iPad is held firmly. 2015 Brydge Global Pte Ltd, All Rights Reserved. iPad and Apple are registered trademarks of Apple, Inc. The Bluetooth word, mark and logos are owned by Bluetooth SIG, Inc. Use of such marks by Brydge Global Pte Ltd is under license. Pair Charge 1) Switch 2) Press 3) Select 4) Confirm Turn your keyboard on by switching the left-hand button to the right. A green dot will appear. Put the keyboard into pairing mode by pressing and holding the right-hand button for 3 seconds. Under Settings / Bluetooth,
(on your iPad) select BrydgeAir - Mini Your iPad will indicate it is connected to the Brydge Keyboard. 1) Flat 2) Insert 3) Charge 4) Charged A flashing blue light indicates the keyboard has less than 10% battery life left. Inset the supplied MICRO USB cable. Charging is confirmed by a solid red light. Your keyboard is fully charged when the light turns off. Note: Charging takes up to 3 hours. Note: Press the Fn button to access the secondary character on the keyboard!
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.