Wireless Remote Power Attaching To Battery:
Module Instructions:
Wireless Remote Power Modul cons of: Power Module wiles a petit remote contra (batteries incuded), two mounting screws, and
[reece Mount red wie sattery topostive 1.Afterinstaling light accessories locate desired position for power |
rhe and ace wih mounting evs ve ae 2.Srech ou white antenna wt and tape down. away fom any Wires toengine ing parts
'3.Connect the positive and negative power wires (used red and SEdomeiaiyempe Sk ite) the appropriate connections tothe more rey ound under the sent Se Dagan Blom 4.Connect the postive and negative contol wires {used yellow Sack wie othe appoint connect on evo
{ceesoryyou wah to control remotely. 5.Based onthe placement of the lights, you may have excess wire. Retain with supplied cable tes (included in packaging) and locate away from moving pants 2.Wrap black Power Module wir around negative pole cock:
wise. Additional insulation may need tobe stripped from wie. Rectighten terminal leaving the wires tothe engine in place. 2 Turing counterclockwise loosen the positive ba Terma comecingbateryienges ney 4.Wrap red Power Module wire around postive pole clock. wise. Re-tighten terminal leaving wires tothe engine in place. Replacing Remote Batteries:
|.Remove screw from back of Remote Control unit and separate cainghaves tron) 2emeve nd discard bate
+3.Replace with 27A 12V battery only, On Off Resse ut Red & Black =. Wires:to 12V0C Power Yellow & Black Control Wires:
Attach To Light (or optional
+ Power Distribution Module) This lagram does not depict all motorcycle layouts Please consult the Owner's Manual for exact positioning ofthe batter. Warning: Battery _Donot mount in. postion that could impalror distract you or others from operating a motor vehicle Use caution when mounting and routing wires to avoid ll moving parts. Especially take nots to not interfere with full otion of stering if you are unsure ofthe instalation procedure pease consulta qualfied automotive/motoreye install. This producti not intended forthe use of children under the age of 7 years. Some sates rohit he se of speci clrs on meter vetices celal es and reuans befor nstaling on entero Pes obey traficaws Models: EPOD-REM Transmitter EPOD-REC Receiver Declaration of Conformity This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions: (1) this device may not cause harmful Interference, and (2) this device must accept any Interference received, Including Interference that may cause undesired operation. CAUTION: Any changes or modifications not expressly approved by the manufacturer could Yold the user's authority to operate this device. NOTE: This equipment has boon tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Those limits are designed to provide reasonable protection against harmful Interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, Hf not installed and used in accordance with the Instructions, may cause harmful interference to radio communications. However, there Is no wuarantes that interference will net occur in a Particular installation. if this equipment does cause harmful Interference to radio or television reception, which can be determined by turing the equipment off and on, the user Is encouraged to tury te correct the interference by one or more of
{the following measures:
onsite datr ofan experienced rao lan for hap Toon eco ee