EN SAFETY INSTRUCTIONS Read the operating instructions carefully before use. Save these instructions for future reference. Protect the appliance and the power cord from heat, sunlight, water and sharp edges. Never poke any metal objects into the appliance risk of short circuiting. Do not use the appliance in extremely dry air risk of static electricity. The product may become warm when charging Do not modify the product the manufacturer cannot accept liability for any The product and antenna must not be located or used in conjunction other antennas or transmitters. Do not attempt to repair the appliance. Any repairs must be carried out by an TECHNICAL DATA Electrical data Bluetooth that supports Range Frequency response RMS-output Distortion Signal/noise ratio Drive unit Output power Battery capacity Operating time Charging time Interface Dimensions Weight 14 VDC, 1 A 3.0+EDR 10 m 80 Hz to 16 kHz 25 W (THD = 10%) 0.5 %
65 dB 2 x 3"
2x12,5 W RMS 2000 mAh 3-4 hours 2-2.5 hours BT, AUX 260 x 150 x 150 mm 2 kg EN EN DESCRIPTION 1 2 3 4 5 6 7 8 1 2 3 4 Bluetooth/AUX input selector Volume setting Play/Pause Power switch Previous song 5 6 Next song 7 AUX input 8 Charger socket (rear) USE When the product is new Charging the speaker 1. 2. 3. Connect the adapter cable to the speaker's charging port. The red status light comes on to show that the product is charging. Pairing 1. 2. Place the speaker within 9 metres of the Bluetooth device. Follow the instructions on the Bluetooth device to search for the speaker. The speaker's name when pairing is M1. If a PIN code is requested, enter 0000. 3. 4. 5. Use Set the switch in the ON position to start the speaker. An audio signal is give and the blue status lamp Status lights Charging Fully charged Pairing mode Connected Playback Red light on Red light out Blue light on 1 2 3 FCC Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. RF Exposure Statement To maintain compliance with FCCs RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna. EN 4