FunboxBLUETOOTH SPEAKER PACKAGE CONTENTS:
14 Funbox Bluetooth Speaker 2. User's Manual 3. USB cable 4, Audio cable CHARGING THE SPEAKER:
Before using the speaker for the first time,charge it for at least 24 hours. 14 Plug the USB cable into the port on the speaker.plug the other end into the USB port on the computer. 2, Red LED will turn on to indicate that the unit is charging. 3. Red LED will tum off when fully charged. 1, Place the speaker near the Bluetooth-enabled device. 2. Slide the ON/OFF button to ON, The blue LED will flash 3 times slowly then flash quickly , The speaker is now in pairing mode. 3. Follow the instructions of your device to search for the speaker. 4. The speaker is calledFunbox" enter the PIN "0000" if needed 5. The blue LED will flash slowly when pairing is complete. BASIC INSTRUCTIONS To tum the speaker on,slide the ON/OFF button to ON .The Speaker will emit a beep and a blue LED will flash slowly. The blue LED will stay on when playing music. The speaker will emit a beep every 20 seconds when the battery is low. To turn the speaker off slide the ON/OFF button to OFF. LED INDICATOR Charging:Red LED on Fully Charged:Red LED off Pairing Mode : Blue LED will flash quickly Connected: Blue LED wil flash slowly Playing:Blue LED will remain on SAFETY AND GENERAL INFORMATION Do not expose the device to water or attempt to disassemble the device if the device is exposed to water or disassembled, the user may be risking an electric short. Handle this product with care,without proper care the device may not function properly Do not use this product in an aircraft or in a hospital. Do not expose the device to direct sunlight. Device may become warm while charging Fee FCC NOTICE This decive complies with part 15 of the FCC Rules
(Operation is subject to the following two conditions;
1. This device may not cause harmful interferece and 2. This device must acopept any interence received. including interfernce that may cause undesired operation FCC CAUTION Any changes or modifications not expressly approved by the party responsible for compliance coule void the user's authority to operate this equipment, This device and its antenna(s) must not be co-locatde or operating in conjunction with any other antenna or transmitter. To cate the FCC and IC identification numbers. please look onthe underside of the speaker. ano: 710058 20 @300 1. Phone Answer and Redial Key-Under Bluetooth connected status,when the call comes in press button quickiy to anser the callpress and hold to change mode between AUX/Biuetooth. 2. Volume down /Last Song :Press quickly for last song ,press and hold to decrease the volume. 3. Volume up/Next Song :Press quickly for next song.press and hold to increase the volume, when volume reaches the maximum limit speaker will beep. 4, Power On/Off 5+ Bluetooth light indicator:Blue light flashing fast=searching for Bluetooth signal Blue light flashing slowly=connected to Bluetooth.Red light on=
charging,once completely charged ,light will turn off. 6. Micro USB :Use a computer USB portipower adapter to recharge the speaker.when battery is low.it will take 4 hours to fully recharge the battery. 7. Audio input(Line-in) PRODUCT SPECIFICATIONS Main device parameters SIN2708 output power:1.7Wx2 battery capacity:2000mAh frequency response: 120Hz-16KHz battery time:up to 4 hours) RMS(THD=10%) battery charging time 3.5-4.5 hours driver 1.5" product size : 165x37x65mm_ power supply:USB DC 5V=: product weight: 300g distortions0.5%
NOTE: This equipment has been tested and found to comply with the requirements for a Cass B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential instalation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does causs harmful interference to radio oF television reception, which can be determined by turning the equpment off and on, the users encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the feceiver is connected
# Consuit the dealer or an experienced radio/TV technician for help. CCauton:Any changes or modifications not expressly approved by party responsible for compiance could void the User's anthouiy o operate this equipment. tN: 7190-58