PBT3011 User Manual
[ i t f Tower Speaker OLS a erate]
F LOCATION OF CONTROLS (CONT):
Polaroid Coie CS ET a. FM Antenna
|4. Main Power Switch: Power ON/OFF ee SSS Eemots Control Pensa!
in tne Dox 1.] button:
POWER ON = Quickpress (make sure the Power Switch is set to ON) POWER OFF = Quickpress User manual 2. [ 4] button: Previous track/Tune down through radio stations in FM mode 3. [+ or [] buttons: Increase/Decrease the volume 4, [NoD=] button: Mode conversion 5. [ 34] button: Mute - turn OFF/ON sound Tower Speaker 6.[>i] button: Next track/Tune up through radio stations in FM mode 3.5mm 7. 1] button: Play/Pause
<s auxiliary cord 8 [RESET] button: Volume recovery system default settings iy 9, [FM SCAN] button:Press & Hold = FM Scan se stan 10. [EQ] button: Switch sound settings 7 = 11. Numeric buttons 2 sets of screws/washers Remote control i f P
: a ad 2 G - x CATION OF CONTROLS: -
NOTE: The battery for the remote control (1 CR205 lithium battery) is included. To Main Unit replace the battery, push and slide out the battery door in the remote control, Replace the battery with anew CR2025 battery with the polarity"+facing up. Slide the door 2 SETUP 1 4 Fel =U! 5 i Nes |
ct T T |
1 i f |
Pea dat | 2 1IRRemote Sensor 2. SD card slot | 2. Bass Speake
+3. AUX INPUT jack 10 987 | ass Speakers 4.Source indicator lights 3. Tweeters
| 4, Base Stand 5, Screws Press & Hold = FM Scan 6. Washers 6.[VOL+] button: Increase volume 7. [VOL] button: Decrease volume 8, [MODE] button: Input sources change button 9. [38] button: Next track/Tune up through radio stations in FM mode Step 1: Connect the wooden base to the 10, [&& ] button: Previous track/Tune down through radio stations in FM mod. main body using the supplied screws and 11.[] button: washers, POWER ON = Quickpress (make sure the Power Switch is set to ON) POWER OFF = Quickpress 6 12. IR remote sensor BASIC OPERATION:
1. Flip Main Power Switch on the rear of the unit to the ON position. 2. Press the [()] button to turn ON the unit. A source indicator will light up GREEN when the unit is ON; the light will go out when the unit is OFF. 3. Press the [MODE] button on the speaker or the [ MODE ] button on the remote control repeatedly to switch the playback source, The Source indicator will light up GREEN accordingly, 4, Press the [VOL+/VOL-] buttons on the speaker or the [+/-] buttons on the remote control to adjust volume level. 5. Press the [EQ] button to set EQ mode as desired, 6. Press the [ ] button on the remote control to turn off the sound. Press it again to turn the sound back on, RADIO OPERATIO 1.Press the [ ] button to turn ON the unit. 2. Press the [MODE] button on the speaker or the remote control repeatedly until the FM indicator turns GREEN. 3. Press the [ ] or [ >>! ] button on the speaker or the remote control to tune down/up through radio stations. 4.To scan to the next available station, press and hold the [>>i] or [<]
button for one full second and release. 5. Press the [FM SCAN] button on the remote control to search all available stations. Press it again to stop on a station. 6. To store preset radio stations in FM Mode:
a, Tune to the station you want to save. b, Press and hold.a numeric button for 3 seconds on the remote control to store the station,
. Numbers between 1 and 9 may be used, For example, if you press and hold1*then you will have programmed Station 1". 1.Insert an SD card (not included) into the SD card slot on the speaker to play MP3 music files. 2. Press the [ @) ] button to turn ON the unit, And you insert an SD card into the SD card slotthen press the [MODE] button on the speaker orth remote contro! repeatedly until the SD indicator lightturns GREEN IMPORTANT: Tracks will play in the order in which they are listed on the playlist on your SD card. Music placed in folders cannot be accessed. Therefore your music needs to be assembled in one complete list-not in folders. 3. Press the [3] button to pause the music, Press the [ sj"] button again to resume play. 4. Press the [yi] button to skip forward to the next track and the
[46] button to skip backward to the previous track. 5.Use numeric buttons to select your desired track. For example, pressing"2"+*0"+"9" means track 209, C2, NOTE: The supported format is the following: MP3 (32kbps-320kbps). The total number of MP3 files on the memory device should not exceed 999. When playing files onSD card, plug in the SD card when the speaker is in Standby mode. Turn the speaker ON and use the MODE button to select SD card mode-There are many SD devices on the market.We cannot guarantee to support all models. please try another SD device if your device is not supported. Some SD cards may not be T BLUETOOTH PAIRING & LINKING OPERATION:
NOTE: To enhance radio reception ability, fully unwind and extend the FM-antenna wire located on the back of the speaker. IARY PLAYBA 1. Plug one end of the included 3.5 mm Auxiliary cord to the headphone jack on your device. 2.Plug the other end of the 3.5 mm Auxiliary cord into the AUX jack on the top of the speaker. 3. Press the [)] button to turn ON the unit. 4. Press the [MODE] button on the speaker or the [ MODE ] button on the remote control repeatedly until the AUX indicator turns GREEN. 5, Use your device's audio controls for music playback. NOTE: You cannot use the speaker controls for audio playback while the device is plugged into the AUX jack. USB Charging:
1. There is a USB charger on the top of the unit that can charge iPhones, iPods and iPads or any device that charges using a standard USB cord. 2. USB cable Is not included, use your device's charging cable. 3, Make sure the speaker is powered ON to charge devices. 1. Keep your Tower Speaker and Bluetooth enabled device within 3 feet of each other during the pairing process. 2. Press and hold the [W)] button to turn ON the unit, 3. Press the [MODE] button on the speaker or the [MODE] button on the remote control repeatedly until the Bluetooth indicator flashes GREEN, The Bluetooth indicator will remain GREEN when pairing is successful. NOTE: Flashing Green: Pairing Mode Solid Green: You are connected to the Bluetooth device. f you would like to.use a new Bluetooth device with the speaker, you must unpair the speaker from your device using your device's Bluetooth menu. If you power off the speaker when itis unpaired, the next time you turn the speaker on the Bluetooth indicator will lash Green which means tis in pairing mode. L]
4, Set your mobile phone or other Bluetooth enabled device to search for Bluetooth devices. within 3 feet EYese Searching for devices 5. When the device finds the Tower Speaker, confirm by selecting zz PBT8011 from the list. Casas Paired Devices:
[eo Select Device:
PLAY MUSIC FROM BLUETOOTH DEVICE 6. SelectPair to connect the Tower Speaker to your Bluetooth enabled device.
(@ No sound is coming from the Tower Speaker.
+The volume level may be too low. Try increasing the volume by pressing the [VOL+] button on the speaker or the [+] button on the remote control.
<The connected device might not be in playback mode, Play music from the connected Bluetooth device.
<The sound output of the connected device is weak. Increase the volume of the connected Bluetooth device. C7 MM Ma MMos can Coe A Try reducing the volume level by pressing the [VOL-] button on the speaker or the [-] button on the remote control. The sound output of the connected device might be too high. Try reducing the volume of the connected Bluetooth device. PBT3011" would like to pair with your phone. Would you like to allow it to pair?
Jevice you are trying to connect th ae eared ero ett uot Te Cees Bluetooth: Enabled Paired Devices:
PBT3011 Enter numeric passkey for PBT3011:
7 Ma ean Ca ere Make sure no other devices are connected to the Tower Speaker and try the connection again. Ifa device was, connected to the speaker, unpair it before connecting your new device. Do this using your Bluetooth device's Bluetooth menu. OK Enter passcode0000 "if prompted by the device, NOTE: Use of this unit near fluorescent lighting may cause interference regarding use of the remote, ifthe units displaying erratic behavior, move it away from any fluorescent lighting, as that may be the cause. LEGAL INFORMATION FCC Part 15:
Ts vice compli wth Pat 15 of th FCC Rules: Operations subject tothe folowing two 7. Your Bluetooth enabled device will confirm that the pairing was completed, and prompt you to accept the connection. Please respond YES to connect the Tower Speaker to your Bluetooth enabled device, EYEeee Paired Devices:
En Accept connection request from PBT3011?
Ce /
& Don'task this again
(1) this device may not cause harmful interfeienice, and
(@) this device must ecoapt any interlerence recewed, including interference that may Callse undesired operation Warning: Changes or modifications to this equipment not expressly approved by the arty responsible for corplisnes could vod the user's auth to operate the equipment NOTE: This equipment as bean weed pt ound to campy with the regutemenes fora Css 8 Sigal doves Under Pat 13 0 the Federal Communccations Commission (ECC) rues, These feguremets ar eee fo prow ressoraae protection eon parm ererenceine fest nsialavon This aqupmant generatos, aes and car adie racho frequency snetuy and if nct
(rind and Weed maccordaneowi the netuctons, may cauuo harm errencs 1 "Sao"
communesvore 8.When attempting to reconnect the Tower Speaker to your Bluetooth enabled device, you may see the message below, and your Bluetooth device will prompt you to accept the connection request to the PBT3011 speaker, and an option not to ask this again. Please accept the connection, and if you select Don't ask this again, your Bluetooth device will automatically accept future connection requests from your Tower Speaker. However, there i no guarantee that interference will not acour in @ particular instalation tf this equipment does casse harmful terferenca fo redo or felovison recoption, wich can be datermined by tia re egret of ono, encorngod toy to cect tho rience by one O more oF the falewing measures
# Reorient or rolacate the recetving antanna. 1 Ineroase the separation between the equipment and receiver,
+ Connect me equment mio an gut en art diferent om that to which the
* Consult the dealer or an experienced radia/TV technician for helo. o not stent to repair or modi this equipment Shisided USB cables must bs used with this unit to;ensure compliance with the Class B FCC limits it your electronic device has intsnal mernory on which personal or other confer dats may be stored, you may want ta perform a data sanftzalon process before you dispase of your aavice to assure another Barty cannot soceas your personel dats, Sata sanitation vares by the ivbe OF frock. and es sokwere. and YE hy st ores he bee sanz press for your even Wore apa You may ato check
{hit your focal recyeing fclty fe determine hon data santzstion proosdures during the recyehng process LIMITED WARRANTY This product as suppliod and distribured naw by AIT, Inc. *AIT*) to the orginal consumer purchaser is warranted by AIT against defects In material and workmanship fora petiod of one year from your date of purchase ("Warranty") in the unlikely overt that this product is defective, or does not perform property, vou may within one year from your original dete of purchase rafurn it to the authorized service center for repair or exchange. TO OBTAIN WARRANTY SERVICE:
* Provide poo! of hed of purchase win he package (Dated il of Prepay all shipping costs to the authorized service. femember to insure your ratum, Include a return shipping address (no PO. Boxes), a telephone contact umber, and the defective unit within the package,
= Describe the defect or reason you are retiring the product. Efe Paired Devices:
Confirm connection to PBT3011?
YES The screenshots above are typicalofmany!
Gene one tn Nese neers at Lr) ce nan ee Ta Preeem gates eae ae ied OT ee a aa ne oe re, anid Your product will he Fepaired of replaced, at aur option, for the sare or similar model of equal valu If examination by the service center determines this product is defective. Products eceived damaged as a result of shipping, will require you to file a claim with the carrer The shipping address of the authonzed service center is AMT, Inc. ATTN: Customer Service (2nd Floor) 14-C 31a Strat Brooklyn, NY 1232 WILL AIT. ITS MANUFACTURERS, DISTRIBLITORS OR PLA IP HOLDINGS, LLC BE LIABLE FOR ANY INCIDENTAL. DIRECT INDIRECT SPECIAL. PUNITIVE OR CONSEQUENTIAL DAMAGES ISUCH AS, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF PROFS, BUSINESS, SAVINGS, DATA OF RECORDS) RELATED TO THIS PRODUCT. EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES SHALL APPLY. Make sure the Bluetooth connection between the speaker and the Bluetooth enabled device is active. (see Bluetooth pairing & linking operation) inn 1. Press the [*8"] button to pause the music, Press the [*P\"] button again to resume play. 2.Press the [>p/] button to skip forward to the next track and the
[44] button to skip backward to the previous track. 3 Press the [VOL+/VOL-] buttons on the speaker or the [+/-]
buttons on the remote control to adjust volume level.
[] within 3 feet Should you have any questions or problems conceming this product, please contact our customer service department at:
Customer Support:
w13777 1 (Toll Free) Monday - Friday: 8AM 1PM (EST)
[2 wewsoutherntalecom.com Click on *Produet Support