B102 BLUETOOTH SPEAKER User Manual

B102 USER MANUAL Product Specification:

Main parameter:

Bluetooth version: V4.1 output power3W frequency response150hz-18khz RMSTHD = 10%

drive2 power supplyUSB, DC 5V 500mA distortion1%

S / N 75dB Charging the Speaker:

Before using the speaker for the first time, charging it for at least 0.5 hours. 1Plug the USB cable into the port on the speaker, plug the other end into the USB port on the adapter(DC 5V). 2Red LED will turn on to indicate that the unit is charging. 3Red LED will turn off when fully charged. Start-up& Shutdown Functions:

1Long press POWER to start the blue-tooth speaker. 2Blue LED g flashes, waiting for pairing 3Long press POWER to shutdown the blue-tooth speaker. 4LED off if shutdown the speaker. Pairing the Device:

1Place the speaker near the Blue-tooth-enabled device. 2Long press POWER to start the blue-tooth speaker, blue LED flashes, the speaker is now in pairing mode.Follow the instructions of your device to search for the speaker. 2The speaker is called B102, enter the PIN0000 if need. 3Blue LED light, the completion of the pairing, while the voice prompts. The speaker is in the state of pairing the last device default in the first 3 seconds after starting. If failing to pair, the speaker will be in state of pairing automatically. LED Indicator 1Charging: Red LED on 2Fully charged: Red LED off 3Pairing Mode: Blue LED flashes. 4Connected: Blue LED slow flashes 5Line IN Mode: Blue LED on 6Low battry: Red LED flashes FCC Warning Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.