Geo Pendant (GPT-1-FD) A. Identifying the Parts 11.. AAccttiivvee//PPeennddaanntt BBuuttttoonn
Press the Active Button to send an activation signal.
Press and hold the Active button for 8 seconds to send a cancel signal. 22.. RReedd LLEEDD
LED OFF: In Standby Mode
RED LED ON: Transmitting signal
RED LED FLASH: Transmitting signal under low battery
RED FLASH 3 times: Low Battery Power on 33.. LLaannyyaarrdd LLoooopp 44.. BBaatttteerryy CCoommppaarrttmmeenntt CCoovveerr B. Battery The Geo Pendant uses one 3V CR2477 lithium battery as its power source. When low battery voltage is detected, a Low Battery signal will be transmitted. When the active button is pressed under low battery status, the Red LED will flash to remind the user to replace the battery. C. Supervision
After the battery is inserted, the Geo Pendant automatically will transmit 3 supervision signals every minute.
If the supervision signal could not be received by the Locator (LT-49) for 5 minutes, the Locator will transmit an Exit signal to indicate the Geo Pendant has left its signal range. If the supervision signal is received again by the Locator, it will transmit an Entry signal to indicate the Geo Pendant has returned to its signal range. D. Specification
Frequency: 433.82MHz (FM)
Power: CR2477 lithium 3V battery FFCCCC SSttaatteemmeenntt This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. FFCCCC CCaauuttiioonn::
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). 1