Remote Controller (RC-16-F1) The Remote Controller is used to arm the system in home or away mode, disarm the system and send a panic signal.
IIddeennttiiffyyiinngg tthhee ppaarrttss 1. Away Arm Buttom Press the button to arm the system in Away Arm mode. 2. Disarm Buttom Press the button to disarm the system. When an alarm is activated, press the button to stop the alarm. 3. Home Arm Buttom Press the button to arm the system in Home Arm mode. 4. Panic Buttom Press and hold the button for 3 seconds to activate a Panic alarm.
<<NNOOTTEE>>
Panic alarm cannot be stopped after activation by pressing disarm button on Remote Controller. 5. LED Indicator The LED will flash when the Remote Control is transmitting radio signal.
BBaatttteerryy The Remote Controller uses one CR2032 3V mAh Lithium battery as its power source. When low battery voltage is detected, a low battery signal will be sent to the Control Panel along with regular signal transmission to notify the Control Panel. Insert the battery according to instruction below:
1. 2. 3. Separate the Remote Controller casing from the middle to reveal the battery compartment. (Figure 1) Insert the battery into battery compartment, with the positive side facing the logo on the back, (Figure 2) Replace the casing. (Figure 3) Figure 1 Figure 2 Figure 3
<<NNOOTTEE>>
When changing battery, after removing the old battery, press any button twice to fully discharge before inserting new battery.
When a low voltage battery is inserted, the LED will flash 3 times to indicate low battery.
GGeettttiinngg SSttaarrtteedd Insert the battery according to instruction.
Put the Control Panel into learning mode, refer to Control Panel manual for detail.
Press any buttons on the Remote Controller.
Please refer to your Control Panel manual to complete the learning process If the Control Panel receives the Remote Controller signal successfully, it will display the information accordingly. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.