FCC ID: 2AA4QT1XRF Wireless Video Camera

Technical Specification Product:

1350RF Vibration level:

Resolution:

Min illumination:

IR LED:

Night Vision distance:

Waterproof rating:

Viewing Angle:

Power voltage:

Operation temp:

Antenna:

Connector:

1280*960 pixels (NTSC) 10G 0.1LUX 8 pcs 16 ft 9V ~ 36V 3DB DTM04-2P IP68 Vertical:71 Horizontal:123 Diagonal:150

-20~+70 / -40~+70 (with heating) Maintenance Although this Rear View Camera requires little care, you can still maintain its condition and performance by following these steps:

Occasionally clean the camera lens with damp soft cloth. Should you experience any problem with the camera please refer to the troubleshooting guide below prior to returning your camera for repair. Note: The user should not attempt to service the unit beyond that described in the operating instructions. All other servicing should be referred to qualified personnel. Hardware Warranty Subject to the provisions described below, our product is protected for One year against defects in material and workmanship. Should a product fail to perform as described above within the warranted period, it will be repaired or replaced with the same or functionally equivalent product by us. This warranty does not apply if , in the judgement of us, the product fails due to damage from shipment, handling, storage, accident, abuse or misuse, or if it has been used or maintained in a manner not conforming to product manual instructions, has been modified in any way. Repair by anyone other than us or an approved agent will void this warranty. The maximum liability of our company under this warranty is limited to the purchase price of the product covered by the warranty FCC Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Warning Statements:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.

FCC ID Label Location 20mm*20mm FCC ID: 2AA4QT1XRF This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Convoy Technologies Inc 6409 Highview Drive, Fort Wayne, Indiana 46818, Fort Wayne, IN 46818, United States Agent Authorization Company: Convoy Technologies Inc Address: 6409 Highview Drive, Fort Wayne, Indiana 46818, Fort Wayne, IN 46818, United States Product Name: Wireless Video Camera Model Number(s): T1XRF, 1350RF Product Description: Wireless Video Camera We authorize MiCOM Labs Inc., 575 Boulder Court, Pleasanton, California 94566, USA, to act on our behalf on all matters concerning the certification of above named equipment. We declare that MiCOM Labs Inc. is allowed to forward all information related to the approval and certification of equipment to the regulatory agencies as required and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Signature:

Date: Jun. 29, 2022 Name:

Edward Cheng Title:

General Manager Company: Convoy Technologies Inc

Convoy Technologies Inc 6409 Highview Drive, Fort Wayne, Indiana 46818, Fort Wayne, IN 46818, United States Jun. 29, 2022 Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 USA Subject: Explanation of differences between product types To Whom It May Concern:

FCC ID: 2AA4QT1XRF Models: T1XRF, 1350RF We, The Convoy Technologies Inc hereby declare that the model : T1XRF is identical with the model : 1350RF, except the model name. Except for the different above, no other modification is performed. Sincerely, Convoy Technologies Inc Signature:

[Edward Cheng, General Manager]

Convoy Technologies Inc.6409 Highview Drive, Fort Wayne, Indiana 46818, United StatesOffice of Engineering Technology Federal Communications Commission7435 Oakland Mills RoadColumbia, MD 21046USADate: July-05, 2022Subject; Request for Confidentiality FCC ID: 2AA4QT1XRFTo Whom It May Concern,Pursuant to the provisions of the Commissions rules Title 47 Sections 0.457 and 0.459, we are requesting the Commission to withhold the following attachment(s) as confidential documents from public disclosure indefinitely.These documents contain detailed system and equipment descriptions and are considered as proprietary information in operation of the equipment. The public disclosure of these documents might be harmful to our company and would give competitors an unfair advantage in the market. Schematic Diagram Block Diagram Operational Description Parts ListIt is our understanding that all measurement test reports, FCC ID label format and correspondence during the certification review process cannot be granted as confidential documents and this information will be available for public review once the grant of equipment authorization is issued.Sincerely,Signature: Name: Edward ChengTitle: Vice President of Products