. Manual Requirement of FCC / IC Our product (ED00250) is one of vehicle parts incorporated into the vehicle as original equipment. Therefore, we will not supply the users manual. However, we will ask the vehicle manufacturer to include following statements in the vehicle users manual in accordance with FCC and IC requirements. 1. Requirement for User Manual 1.1. FCC Requirement 1.1.1. In accordance with 15.21 of FCC rule, following statement will be included in the users manual. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC WARNING 1.1.2. In accordance with requirement of FCC15.19(a)(5), following statement will be included in the users manual. NOTE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 1.2. IC Requirement 1.2.1. In accordance with requirement of RSS-GEN, following statement will be included in the users manual. NOTE Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas provoquer de brouillage, et (2) l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Smart Key ECU Product Outline The Smart Key system is a comfort feature that allows the user to lock, unlock the doors of the vehicle without using a mechanical key. The user has to carry with him the Smart Key Fob as a wireless authentication is performed when toggle button or Start Stop Button inputs are triggered. For communication with the SMART Key FOB, Smart Key ECU generates a request (challenge) as an encoded and modulated signal (134.2 kHz..) at the inductive antenna outputs and receives the SMART Key FOB's response via the external RF ANT and internal receiver This product is installed inside the vehicle. Product Description Product Type Number RF characteristic Nominal frequency LF characteristic Nominal frequency Local oscillator frequency RF Antenna Local oscillator frequency LF Antenna Nominal frequency Local oscillator frequency Transponder Antenna Nominal supply voltage Transponder characteristic Power Supply Appearance Unit : mm ED00250 433.92MHz 21.948717MHz (Crystal) Internal antenna 134.2kHz 4.026MHz (Crystal) External antenna (Ferrite antenna coil) 134.2kHz 4.00MHz (Ceramic Resonator) External antenna (antenna coil) 12V DC