Smart Key ECU EG00040 Product Outline The Smart Key system is a comfort feature that allows the user to lock, unlock the doors of the vehicle without using a mechanical key. as The user has to carry with him the Smart Key Fob a wireless authentication is performed when toggle button or Start Stop Button inputs are triggered. For communication with the SMART Key FOB, Smart Key ECU generates a request (challenge) as an encoded and modulated signal (134.2 kHz..) at the inductive antenna outputs and receives the SMART Key FOB's response via the external RF ANT and internal receiver Product Description Appearance 155 135 Unit : mm 33 Unit : mm RF characteristic LF characteristic Transponder characteristic Power Supply Nominal frequency Local oscillator frequency RF Antenna Nominal frequency Local oscillator frequency LF Antenna Nominal frequency Local oscillator frequency Transponder Antenna Nominal supply voltage 433.92MHz 37.95625MHz (Crystal) External antenna 134.2kHz 4.2944MHz (Crystal) External antenna (Ferrite antenna coil) 134.2kHz 4.00MHz (Ceramic Resonator) External antenna (antenna coil) 12V DC FCC ID: CQOEN00040 FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.21 Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment. IC: 1151E-EN00040 Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.