PURPLELEAFLI Model:X30 Product:wireless earphone To charge Battery Before the rst ues of bluetooth headset battery must be full of charge rstly 1.The charger wire connected to the charging socket on the headset. 2.Insert the charger into the power switch. 3.The charging indicator light shows red, once fully charged , the blue light glows. 4.To isolate the charger from the headset and power socket. 5.The charging is complete. ON/OFF switch machine 1.Boot:hold down the start/end call button for about 6 seconds, untilthe alternating red and blue. 2.To turn it off:hold down the start/end call about 3 seconds, until closed. Chinese and English switching 1.After the headset is turned on, press the function key for 2 times. To pair the Headset With a Biuetooth Enabled Phone 1.Open the headset,hold down the function keys about 6 seconds to red and blue lights ashing. 2.Set the phone to search for bluetooth devices. 3.When the phone search to headphones,search to the list to determine the headphones. 4.If the pairing is successful.blue lights will ash ,at this point the standby mode are ready to dial/accept the call. To Answer a Call Press the start/end call button on the headset. To end a call Press the start/end call button on the headset. To Reject a Call When the phone rings continue to hold the start/end call button on the the headphones for about 2 second. To Redial the Last called Number 1.In standby mode click headsets start/end call for about 2 seconds to loosen. Song switch up and down 1.Long press the "+" key to change the previous song. 2.Long press the "-" key to change the next song. To Adjust Volume of Headset 1.Short press the"+" key to increase the volume. 2.Short press the "-" key to reduce the volume. Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the in instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help. Warning: Changes or modications to this unit not expressly approved by the part responsible for compliance could void the users authority to operate the equipment. FCC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. FCC ID:2AQUKX30EARPHONE