INSTRUCTION BOOK 1. +Key:
Short press next song, long press the volume to increase 2. -Key:
Short press previous song, long press the volume to decrease 3. Key:
Play state short play / pause, mobile phone bluetooth and bluetooth sound When the box connection is successful, short press the button to answer an incoming call, Ione press this key to hang up the call, double click to make a call 4. "M"Key:
Click this button to change FM frequency range 87.5-108MHz mode and bluetooth mode. 5. key:
Power switch:Switch off for shutdown, dial to ON for start up 6. USB reader:
Key: U disk interface:play the mp3 in the U disk 7. reader:
Key: TF card slot: play the mp3 file in the TF card 8. Charger slot use the micro USB cable to charging 9. AUX FCC WARNING STATEMENT Changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)
(2) This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.