ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS Programming Instructions:
1) Ensure the vehicle is off and not running. 2) Have both the old and new remote available. 3) Insert the key into the lock found outside on the drivers outer door. 4) Turn the key to the unlock position five times within 5 seconds. 5) The (DIC) Driver Information Center displays Ready to Learn Electronic key #2,#3 or #4. 6) Place the new remote into the transmitter pocket with the buttons facing the front of the vehicle. (The transmitter pocket is inside the center console between the driver and front passenger seats). 7) A beep sounds once the remote is programmed. The DIC displays ready to learn electronic key #3 or 4 or maximum # electronic keys learned. 8) Press the ignition control knob to exit the programming mode. 9) Remove the remote from the transmitter pocket and press unlock to the remote two times. 10) To program any additional remotes, repeat steps 6 through 9. FCC WARNING Statement 15.19(a)(3): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the users authority to operate the equipment. FCC Part 15.21: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT. IC WARNING FVIN 6399389IC 6399390IC, 6399391IC The term IC before the Certification/Registration number only signifies that the Industry Canada technical specifications were met. This device complies with Industry Canadas license-exempt RSSs Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference including interference that may cause undesired operation of the device. Le terme IC avant le numro de certification / enregistrement ne signifie que les spcifications techniques d'Industrie Canada ont t remplies. Cet appareil Est conforme aux flux RSS exempts de licence d'Industrie Canada Le fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer Les interfrences et (2) cet appareil doit accepter toute interfrence, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de l'appareil.