13) ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS Programming Instructions:
1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) Make sure all doors are unlocked when you begin. Turn the ignition to the ON position. Press the LOCK or UNLOCK button on the remote. Turn the ignition to the ACCESSORY or LOCK . Turn the ignition to ON Press the lock or UNLOCK button on same remote. Turn the ignition to ACCESSORY or LOCK. Turn the ignition to ON Press the LOCK or UNLOCK button on the same remote Turn the ignition to ACCESSORY or LOCK Turn the ignition to ON Press the LOCK or UNLOCK button on the same remote. Make sure the door locks cycle to indicate that the system has entered programming mode. Press the lock button on each remote that you want programmed. Make sure the doors locks cycle each time to indicate that remote has been accepted. The system will accept up to three remotes. Turn the ignition to LOCK to exit the programming remote. Test all remotes. 14) 15) FCC WARNING 15.19:
This device complies with part 15 of the fcc rules. Operation Is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21:
Note: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the users authority to operate the equipment. IC WARNING FVIN 63999358IC The term IC before the Certification/Registration number only signifies that the Industry Canada technical specifications were met. This device complies with Industry Canadas license-exempt RSSs Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference including interference that may cause undesired operation of the device. Le terme IC avant le numro de certification / enregistrement ne signifie que les spcifications techniques d'Industrie Canada ont t remplies. Cet appareil Est conforme aux flux RSS exempts de licence d'Industrie Canada Le fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer Les interfrences et (2) cet appareil doit accepter toute interfrence, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de l'appareil.