Wireless Optical Mouse User Manual Feature 1 2.4G frequencydigital cordless with distance up to 5-7meters 2 Internal 65000 group ID codeplug and play 3 1000/1500/2000DPI, high-precision and high- stabilization 4 low power consumptionautomatic sleeping function. Compatible IBM PC and compatiblesWin98SE/Me/2000/XP/VISTA /Win7 operating systemno need driver Installation 1 Take the receiver from the packingplug onto the USB port of PC or BOTEBOOKafter a few minutesthe software of receiver will be installed automatically. If it is Win98SE system you need to follow the prompting frame to finish the installation. 2 Open the battery coverput into 1 AA size batteryPay attention to the battery polarity 3 Indicator light will flash for a few seconds 4 You can use it till you can find the curser on the PC screen Reset Wireless mouses remitter and receiver has storage the same group ID codeIt will make sure the mouse remit and receive the corresponding data. If any of ID code for each group disappear or disaffinity, the mouse will not workand you need to reset it. 1 Insert the receiver on the USB port, the indicator light will flickerthen put battery into mouseturn on the mouse. 2 When the indicator light flickerspress the right key of emitterthen press the middle key for three seconds, emitter will emit corresponding codethen the connection finished. 3 Move the mouse and you will find the curser on the PC screen. NoteDont always press the ID switchunless the ID code will be reset and you need to reconnect the mouse. CPI 1000/1500/2000CPI can shift be adjusted, the DPI will change if you press the switching on the top of the mouse. Tips 1. The work distance is about 5-7 meters, but it will be less if there is any barrier. 2. This mouse uses laser light as transfer checking, it comply with correlative safe standards, please do not look into the bottom of the mouse 3. directly. It has automatic sleeping function, the mouse will sleep if you dont use it for about 10 minutes, just press any key to rouse it. 4. Take off the battery if you dont use the mouse for a long time. 5. Change the battery in time please. 6. Automatic ID code memory functionjust reconnect it if the ID code reset. 7. You can store the receiver in the emitters abdomen storage compartment if you dont use it. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Remark This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.. This limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates radio frequency, if not installed and used according to the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measure.
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
* Consult with the dealer or an experienced radio/TV technician for help