FCC ID: 2AW4A-EYEDASHAI EYEDASH AI

EYEDASH AI Simple operation manual I Product introduction This product is a 4channel AI intelligent 4G dash camera, built-in one channel, external Three Channel HD vehicle DV camera, built-in AI intelligent algorithm, one button emergency alarm, capture, platform intercom, GPS positioning, driving track, WiFi hotspot, 4G and TF card storage in one vehicle networking product. II Product features H.265 & H.264 encoding and decoding,Save storage space and transmission flow Support 4-channel 1080p * 15fps / 2-channel 1080p *

30fps, 4-channel 720p, D1 and other codecs;

in one 1080p camera and external Built three HD cameras for easy installation;

Special file system to improve disk reading and writing efficiency,More stable video recording III Product operation and installation 1. Installation instructions Selection of TF Card: it is recommended to select a large brand and high-quality TF card. It is recommended to use more than class 10, with a capacity of 8GB to 256GB. Format of TF Card: before using the new TF card, if the TF card has data to be backed up, please back up first,Then insert the TF card into the device, and the new card device will automatically format the TF card, which can be used only after formatting. Built in 2CH AI intelligent algorithm, which can support 2. Install 4G card and TF Card ADAS, DMS and BSD functions Built in GPS + Beidou dual-mode precise positioning Support 1 TF card,super capacitor double guarantees the Remove the protective cover and install Micro sim cardand video memory cardTFcard. the 4G card integrity of video files Support 1 SIM card, 4G module can support global frequency band Support WiFi hotspot. Support mobile app, client, platform software preview video and parameter configuration Support 4CH IO alarm input and 2CH of RS232 Built in speaker and microphone, Support voice intercom between dash camera and platform. TTS voice broadcast;

low-power One key SOS emergency alarm; Support sleep 3. nstallation and fixing

(1). Find a good angle in the car.

(2). Remove 3M dust-free adhesive tape from the bracket.

(3). Stick it on the windshield before washing the car.

(4). Clip the equipment onto the bracket.

(5). Power on. 4.2 Two sets of wiring definitions are shown in the following figure:

4.2.1 Internal line: 10PIN BMW female power input, two RS232 serial ports (optional), video output, ch2-4 video input, GPS antenna interface 4. Wiring diagram and wire use definition 4.2.2 Function line: one end is 10PIN BMW male power output, which needs to be connected with 10PIN female head of internal line; Support SOS one key alarm and four IO inputs; ACC signal, ground wire, power input 10-36v and other functions. 4.1 Please refer to the schematic diagram above for the wiring mode, is the reference position, please select according to the actual situation. 5. Device indicator description The indicator light is at the lower left in the direction of the heat sink of the equipment, as shown in the figure. After power on, the red power indicator is on, and the corresponding green indicator is defined as follows:

(1) Successful platform networking + normal video recording (always on),

(2) Successful platform networking + no video recording (flash),

(3) The platform is not networked + video recording

(flashing at 1 second intervals),

(4) Platform not networked + not recorded (off). 6.1.1 Remote real-time video, playback and setting Select "playback" under TViewer APP and select date /

time to enter playback mode; Click "setting" to enter the main menu, no password, the corresponding function for setting you can select 6. Function setting and connection description 6.1 Mobile direct connection modeTViewer APP After power on, the Android phone turns on the WiFi function,search the WiFi opened by the "T5304" device. The password is 88888888 Click Connect; Click TViewer APP preview page,Automatic search device, showing the device being scanned. If the device cannot be searched, you can manually click the search flag to search. 6.1.2 AI setting Select the AI setting menu, enter the built-in software option, select the corresponding channel of DSM / ADAS and save it. 6.1.3 Calibration setting Select the calibration menu. When ADAS is calibrated, ask the vehicle to go straight in the middle of the lane. The vertical line and the line is the lane center horizontal line is the horizontal line where the sky road ahead disappears. Point the cross line and adjust it by moving up / down / left / right. After calibration, click

"start calibration". When DSM is calibrated, click the "start calibration"

button, the driver face the front and will automatically calibrate successfully in about 3 seconds. 6.2 Platform access modeCMSV6 After successful 4G dialing, the 808 protocol is used by default. The video stream is H.264. Please select G711a for audio format. To open CMSV6 software, you need to register the account and password of the platform on the official website. The login interface is shown in the figure below Please download the specific operating instructions from the platform's official website or consult the platform service personnel After entering the CMSV6 interface, you can connect the equipment through the equipment number, and the specific functions are visible at the top of the menu. 6.2.1 Remote live preview Open CMSV6 Software > Video. After selecting the device, double-click the CH1~ CH4 icon to open the recording channel, As shown below. 6.2.2 Remote intercom and monitoring Select the mdvr device and the corresponding channel, double-click to open the video of the channel, click the left mouse button in the video box, and select "Start Intercom" or "Start Monitor" to use the intercom and monitoring functions, as follows 6.2.3 Remote positioning and trajectory CMSV6 Software > track to view the positioning and historical track of the selected vehicle.as follows:

7. Simple troubleshooting Phenomenon Operation method Device not online Whether the equipment is powered on SIM card in arrears or no traffic Whether signal are in good condition the 4G antenna and Abnormal equipment positioning Can't even get on WiFi underground Whether GPS antenna and signal are in good condition Is there no GPS in the area (such as and tunnel) Whether the WiFi function of the equipment turned on and whether the WiFi signal is poor. garage is FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two con ditions: (1) this device may not cause harmful interference, and (2) this device must accept any i nterference received,including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for Compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable p rotection against harmful interference in a residential installation. This equipment generates use s and can radiate radio frequency energy and, if not installed and used in accordance with the in structions, may cause harmful interference to radio communications. However, there is no guar antee that interference will not occur in a particular installation. If this equipment does cause har mful interference to radio or television reception, which can be determined by turning the equip ment off and on, the user is encouraged to try to correct the interference by one or more of the f ollowing measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help important announcement . Radiation Exposure Statement To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

label and location FCC ID: 2AW4A-EYEDASHAI Fig.1 FCC ID:2AW4A-EYEDASHAI Contains ID:XMR201903EG25G EYEDASH AI Model: EYEDASH AI Shenzhen TJoin Video Technology Co., Ltd.

EYERIDE LLC 113 E Main St Pflugerville Texas United States Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 2023-2-20 To whom it may concern:

We, EYERIDE LLC , hereby certify that the equipment for which authorization is sought

(FCC ID: 2AW4A-EYEDASHAI) is not covered equipment prohibited from receiving an equipment authorization pursuant to 2.903 of the FCC rules. We also certify that, as of the date of the filing of the application, we are not identified on the Covered List (https://www.fec.gov/supplychain/coveredlist) as an entity producing covered equipment. By signing this form, we confirm the above and that we are aware of the application requirements listed under 2.911(b) and (d)(5) and (6). Sincerely, wy >

Signature Michael Wiegler Manager EYERIDE LLC The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 DO1.

CONFIDENTIALITY REQUEST for Certification Service in USA Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21046 Date:<2023-2-20>

Pursuant to Paragraphs 0.457 and 0.459 of the Commissions Rules (47 C.F.R.) and Section 552(b)(4) of the Freedom of Information Act, we requests confidentiality for the following products:

FCC ID 2AW4A-EYEDASHAI Model name EYEDASH AI For the product stated above, we request that the following information be held confidential;

Exhibits Long-Term Confidentiality Short-Term Confidentiality Short-Term Confidentiality Days External Photos Internal Photos Block Diagram Schematics Xd Md Test Setup Photos User's Manual Parts List Tune Up Operational Descriptions

The long-term confidentiality exhibits contain our trade secrets and proprietary information that could be of benefit to our competitors. The short-term confidentiality on the basis of ensuring that business sensitive information remains confidential until the actual marketing of our new device. If you have any questions, please feel free to contact me at the address shown below. Sincerely, aon Name/Title:

Company:

Address:

Phone:

Fax:

E-Mail:

Michael Wiegler/Manager EYERIDE LLC 113 E Main St Pflugerville Texas United States 833-393-7433 954-775-1201 info@eyeride.io

EYERIDE LLC 113 E Main St Pflugerville Texas United States Date: 2023-2-20 FCC ID: 2AW4A-EYEDASHAI Model Number: EYEDASH AI To:

Federal Communications Commission. Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD To Whom It May Concern, We, EYERIDE LLC , declare that this EUT (FCC ID: 2AW4A-EYEDASHAI) doesnt have Ad Hoc mode function on non-US/ Canada frequencies. In addition. The frequency selection feature is disabled by firmware for devices marked to the US/Canada. For DTS part of this device, only channels 1-11 will be used in North America, Country code selection is disabled. Should you have any questions or comments regarding this matter, please have my best attention. Sincerely, 3 AI DS Name/Title: Michael Wiegler/Manager Company: EYERIDE LLC Address: 113 EMainSt Pflugerville Texas United States Phone: 833-393-7433 Fax: 954-775-1201 E-Mail: info@eyeride.io

EYERIDE LLC 113 E Main St Pflugerville Texas United States Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 2023-2-20 To whom it may concern:

We, the undersigned, hereby authorize Eurofins Product Service GmbH to act on our behalf in all matters relating to applications for equipment authorization FCC ID: 2AW4A-EYEDASHAI including the signing of all documents related to these matters. Any and all acts carried out by Eurofins Product Service GmbH on our behalf shall have the same effect as acts of our own. By signing this application form, we agree to Eurofins current valid General Terms and Conditions

(AGB),Testing and Certification Regulations (PZO) which can be viewed on following website www.eurofins.de/ee or retrieved on request. We also hereby certify that no party to this application is subject to a denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Sincerely,

) C a JN Name/Title: Michael Wiegler/Manager Company: EYERIDE LLC Address: 113 E Main St Pflugerville Texas United States Phone: 833-393-7433 Fax: 954-775-1201 E-Mail: info@eyeride.io

Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 U.S. Agent Designation EYERIDE LLC 2/16/2023 EYERIDE LLC acknowledges their consent for the following contact located in the United States to act as their agent for service of process for the equipment for which authorization is sought (FCC ID:

2AW4A-EYEDASHAI):

Name and company of U.S. agent:EYERIDE LLC Physical U.S. address of agent:113 E Main St Pflugerville, TX 78660 FRN of U.S. agent:0029810496 Email address of U.S. agent: info@eyeride.io EYERIDE LLC acknowledges their obligation to accept service of process on behalf of EYERIDE LLC. EYERIDE LLC accepts its obligation to maintain an agent for service of process in the United States for no less than one year after either the grantee has permanently terminated all marketing and importation of the applicable equipment within the U.S., or the conclusion of any Commission-related administrative or judicial proceeding involving the equipment, whichever is later. By signing this form, we confirm the above and that we are aware of the application requirements listed under 2.911(d)(7). Sincerely, Signature

[Name] Michael Wiegler

[Title] CEO 3 0 V

[Company] EYERIDE LLC

, U

) 7

) d

1 1 9 2 _ t n e g A _ S U

l e d o m

_ 8 4 Signature

[Name of U.S. agent] Michael Wiegler

[Title of U.S. agent] CEO

[Company of U.S. agent] EYERIDE LLC The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 D01. An expiration date for this letter does not exist. In case the U.S. agent changes, the grantee is obligated to notify the FCC.