TRANSMI LOCATION AND FUNCTION OF F HANDHELD MICROPHONE (AWX'
1. Grille: Protects the cartridge and help re noise. 2. Battery Cover: Open itto install the batte 3. Low Battery Indicator: Red lightglows w renew the battery. 4.Power and Audio Mute Switch. SPECIFICATIONS TRANSMITTER Carrier Frequency Range U Frequency Stability J Modulation F Modulation Depth 4 Output Power 1. Spurious Emission Current Consumption Dimensions (W X H X D) Handheld:
ITTER PARTS AND CONTROLS 6070)
ee educingthe breath sounds and wind ary. vhenit islack of power and should JHF Band
+0.005%
-requency Modulation (FM) x1.5V AA Battery 9.4" X2.0" X2.0" (240x51x51mm
BELT-PACK TF 1. Power and Audio 2. Antenna: Transm 3. Belt Clip: Attach t 4. Audio Input Jack:
5. LowBattery Indi renew the battery. 6.Lavaliere Micropt 7.Headset Microphc SPECIFICATIO TRANSMITTER Carrier Frequenc Frequency Stabi Modulation Modulation Depth Output Power Spurious Emissio Battery Current Consump Dimensions (W X TRANSMITTER RANSMITTER ( Awx6070B-Mor AWX6070B-H)
i
dF
. Mute Switch. lit the RF signal of transmitter. thetransmitter to the belt.
: itis suitable for lavalier system/headset system. icator: Red lightglows whenit islack of power and should
. hone(forAWX6070B-M) one(for AWX6070B-H) INS UHF Band
+0.005%
Frequency Modulation (FM) 30mW, Max
>55dB
| 2x1.5VAA Battery
| <4OmA Belt-Pack: 2.6" X3.9" X1.1" (65x100x30mm) FCC Caution. 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subj ect to the following two conditions: (1) This device may not cause ha rmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation 15.21 Information to user. Any Changes or modifications not expressly approved by the party resp onsible for compliance could void the user s authority to operate the equipment. 15.105 Information to the user. Note: This equipment has been tested and found to comply with the lim its for a Class B digital device, pursuant to part 15 of the FCC Rule s. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment g eherates uses and can radiate radio frequency energy and, if not inst alled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If th is equipment does cause harmful interference to radio or television r eception, which can be determined by turning the equipment off and on
, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from tha t to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help