Nick Name
Devices
Press a device to start connect!
instruation
c
itcenno
instruation
c
itcenno
g
g
n
n
START
ENGINE
Goal
Workout
Data
Instruction
Platform
Press switch, blue light turn on.
Platform
Blue light flashing(cid:59003)pair to your phone.
Platform
Becoming green light,Bluetooth connect
successed.
Platform
Clip resistance bands on platform.
Platform
Change resistance as you need through
adjust Mesh belt length. push button on
buckle to draw out or take back mesh belt.
Platform
3pcs of workout bar connection.
Platform
2pcs of workout bar connection.
Platform
If you need more resistance from the same
bands, change a way to connect is always
a good option.
Platform
If you need more resistance from the same
bands, change a way to connect is always
a good option.
Platform
Bands can clip on both rings of platform.
Platform
Each side of smart sensor can hold up
50kgs/100lbs of resistance from bands, ap-
proximate 4pcs of 30lbs green bands or
3pcs of 40lbs black bands.
Platform
Each side of smart sensor can hold up
50kgs/100lbs of resistance from bands, ap-
proximate 4pcs of 30lbs green bands or
3pcs of 40lbs black bands.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
(cid:1068) Reorient or relocate the receiving antenna.
(cid:1068) Increase the separation between the equipment and receiver.
(cid:1068) Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
(cid:1068) Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be
usedin portable exposure condition without restriction.