Anemometer Instruction Manual Model No.: HoVR 1.0 barometric pressure calibration. You can calibrate according to the barometric pressure in your local. Press to go up in units, press to go down in units. After the adjustment is completed, press and hold again, the date will be saved and it will exit to the calibration mode. 3) Press each time, it will circulated among ,
, RH%:
: Centigrade; : Fahrenheit; RH%: Relative Humidity;
7) Press each time to select MAX, AVG, MIN of wind speed. Press and hold for above 3 seconds, back light will turn on. Press and hold for above 3 seconds again, it will turn off. 8Open the Bluetooth of phone and anemometer power, The anemometer will be automatically connected to the phone. Or you can check the name of Bluetooth on the phone. Above picture and content just for your reference. Please be subject to the actual products if anything different or updated. Please pardon for not informing in advance 1. Function:
1) Wind speed measurement 2) Barometer indicator 3) Temperature/humidity/
4) Altitude measurement 5) Measure wind speed in: Current/Max/Min/Average 6) Low battery warning 7) LCD back-light 8) Auto / Manual power off (Note: It will not auto power off in the interface of barometer indication) 2.Operation 1) Put battery into battery compartment. 2) Recover battery cover, screw down pressin 1 second to turn on the unit. LCD will display wind speed, temperature and battery icon. Press again, it will power off. 4) Press to select different wind speed unit: Press each time, it will circulated among m/s, Km/h , Ft/min, Knots,and MPH . Digit symbol:
m/s: meter per second; Km/h: kilometer per hour;
Ft/min: feet per minute; Knots: nautical mile per hour;
MPH: mile per hour. 5) Press to select different barometric pressure unit:
Press each time, it will circulated between inHg and hpa mbar. Press and hold for above 3 seconds, it will enter to the reading of barometric pressure mode. There are total 16 groups data, and record the barometric pressure in 2 hours per time. Now you press it, you can check the 16 groups data. Press and hold again, it will exit to the reading of barometric pressure mode. Digit symbol:
inHg: inches of mercury hpa mbar: millibars / hectopascals. 1(inHg) =33.8638816(hpa) 6) Press to select altitude unit, press each time, it will circulated between M and FT. Note: As the altitude is the conversion from atmospheric pressure, in different periods, the uneven air density which is caused by climate will lead to different altitude. Digit symbol:
M: meter; FT: feet. 1(m)=3.2808399(ft) Press and hold , it will go into the mode of FCC Statement no guarantee that interference will not occur in a particular installation. If this equipment does cause This device complies with part 15 of the FCC rules. harmful interference to radio or television reception, Operation is subject to the following two conditions: (1) which can be determined by turning the equipment off this device may not cause harmful interference, and (2) and on, the user is encouraged to try to correct the this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. IC Caution.
- English:
susceptible d'encompromettre le fonctionnement. L'appareil a t valu pour rpondre aux exigences This device complies with Industry Canada gnrales d'exposition aux RF. L'appareil peut tre licence-exempt RSS standard(s). utilis dans une condition d'exposition portable sans Operation is subject to the following two conditions: (1) restriction. This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
- French:
Le prsentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitationestautorise aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradiolectriquesubi, mmesi le brouillageest