FCC ID: XO8-HALOM418 Mini Halo Transmitter

Instant Care Halo Transmitter Model #: HaloM418TX-1 Identifying the Parts 1. Emergency Button 1 Learning-in the Halo Transmitter Press the Emergency button, a radio signal will be transmitted to the Control Panel. Please refer to the learn-in procedure of your PERS Console for further instruction. Operation To Trigger an Emergency, Call on your PERS Console:

Press and hold the Emergency button for 1 second and release. The device will transmit the message to the PERS Console. Sleep Mode:

-The Halo Transmitter ships in Sleep Mode to conserve battery life

-Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode Battery & Electrical Specifications Frequency: 418MHz Battery: CR2032, 3V 230mAh Battery life: Approximately 3 years Open Field Range: Approximately 250+ ft Low battery status: when the device battery is detected to be below the threshold, a low battery signal is transmitted to the PERS console every 6 hours. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may void the users authority to operate his equipment. (Example use only shielded interface cables when connecting to computer or peripheral devices) FCC Section 15.105 Information to the user. NOTE:

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help. FCC ID: XO8-HALOM418 rev. 001 Instant Care Halo Transmitter Model #: HaloM418TX-2 Identifying the Parts 1. Emergency Button 1 Learning-in the Halo Transmitter Press the Emergency button, a radio signal will be transmitted to the Control Panel. Please refer to the learn-in procedure of your PERS Console for further instruction. Operation To Trigger an Emergency, Call on your PERS Console:

Press and hold the Emergency button for 1 second and release. The device will transmit the message to the PERS Console. Sleep Mode:

-The Halo Transmitter ships in Sleep Mode to conserve battery life

-Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode Battery & Electrical Specifications Frequency: 418MHz Battery: CR2032, 3V 230mAh Battery life: Approximately 3 years Open Field Range: Approximately 250+ ft Low battery status: when the device battery is detected to be below the threshold, a low battery signal is transmitted to the PERS console every 6 hours. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may void the users authority to operate his equipment. (Example use only shielded interface cables when connecting to computer or peripheral devices) FCC Section 15.105 Information to the user. NOTE:

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help. FCC ID: XO8-HALOM418 rev. 001

HaloM418TX-1 Diagram Label location Label location Model: HaloM418TX-1 FCC IDXO8-HALOM418 HaloM418TX-2 Diagram Label location Label location Model: HaloM418TX-2 FCC IDXO8-HALOM418

Instant Care, Inc.. 2080 Wineridge P!.Suite A, Escondido, California, United States, 92029 To: SGS North America Inc. 620 Old Peachtree Road SUITE 100 Suwanee, Georgia United States From: Instant Care, Inc, 9750 Birch Canyon Place San Diego, CA 92126 United States Regarding: Confidentiality Request regarding application for FCC ID: XO8-HALOM418 LONG TERM CONFIDENTIALITY Pursuant to 47 CFR Section 0.459 and 0.457 of the commission's rules, the applicant hereby request confidential treatment of the documents listed below, associated with the certification application referenced above. Schematic(s) Block Diagrams Operational Descriptions The documents above contain proprietary information not released to the public. Public disclosure of this information may prove harmful to the business of the applicant. Instant Care, Inc.

Instant Care, Inc.. ;

2080 Wineridge PI.Suite A, Escondido, California, United States, 92029 To: SGS North America Inc. 620 Old Peachtree Road SUITE 100 Suwanee, Georgia United States From: Instant Care, Inc. 2080 Wineridge PI.Suite A, Escondido California, United States, 92029 Regarding: Appearances difference letter regarding application for FCC ID XO8-HALOM418 APPERANCES DIFFERENCE LETTER Halo Transmitter only has different appearances and the internal architecture is the same. Model Apperances HaloM418TX-1 HaloM418TX-2 Printed Name: Rich Darling Title: CEO Company Name: Instance Care, Inc.