Federal Communications Commission (FCC) Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits ofa Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installations, if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient / Relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that the receiver 1s connected. 4. Consult the dealer or an experienced radio / TV technician for help. Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the users authority to operate the equipment. 20M mB NL rk kN WS ck ENGLISH
. The light normally stays off, and will light
| go through these steps. None of the steps, nme on briefly, and will normally stay off. 1 the screen will move accordingly. ised the power button or re-plugged uch pad to activate the left button (resume 10de. A built-in power saving function may six minutes. king continuously; it will stay off when the LED will stay on for two seconds, and the on (ES) will appear in the system Task Bar ver the working area will cause the cursor on ation or long fingernail(s) may influence the ising the touch device.
(5) to set up (check the user manual for
[fh 1 =
has gone into standby mode. e when not in use. and double click. has gone into standby mode. When you use the battery, carefully read and strictly observe the Safety Instructions and the notes described below:
@ Different battery types and surrounding temperatures may affect the battery performance.
@ Avoid using batteries in extremely cold environments as low temperatures can shorten the battery life and reduce wireless device performance.
@ If you are using a new rechargeable battery or rechargeable battery that has not been used for an extended period of time (batteries that pass the expiry date are exceptions) it might affect the period of time you can use this device. Therefore, to maximize their performance and lifetime, we recommend that you fully charge the batteries and discharge them for at least one complete cycle before use. M@ The battery may feel warm when using the wireless device for an extended period of time or using the flash continuously. This is normal and not a malfunction.
@ The wireless device may feel warm when being used continuously or for an extended period of time. This is normal and not a malfunction.
@ If you will not be using the batteries for an extended period of time, remove them from the wireless device to prevent leakage or corrosion.
@ Always keep the terminals in a clean state. M@ Never use manganese batteries.
@ Risk of explosion if battery is replaced by an incorrect type.
@ Dispose of used batteries according to the instructions.