Ozone Wireless Charging Pad with Dual Outputs Instruction Manual AB0028 INSTRUCTIONS:
1. a. b. 2. a. b. c. d. Connect the provided Micro-USB cable to the USB plug adapter. Connect the Micro-USB tip to the input port on the charging pad. Charging Mobile Devices:
Ensure that your phone or tablet supports wireless charging. It will be listed in the Place the enabled device on the surface of the wireless charging pad. The device should display charging indicator. When completely charged, remove the device from the charging pad. Or Insert corresponding charging cable into the Charging Pad USB port to charge your devices normally. 1. 2. 3. 4. Charging Pad Surface USB Output Port (2) LED Indicator Micro-USB Input Port Whats included:
1 x Wireless Charging Pad 1 x USB to Micro-USB Charging Cable 1 x Instruction Manual
Input power: DC 5V/2000 mA Output power: 5W Product size: 98x 98 mm Dual USB Outputs: DC 5V 1A/1A 30 cm standard Micro-USB cable
*
Note: To charge devices, use only the accessory cable or the cable included with your own device by the manufacturer. SAFETY PRECAUTIONS:
Read all the instructions before using the product.
WARNING-When using this product, basic precautions should always be followed:
Read all the instructions before use. Never store or use this product in temperatures below 32F (0C) or above 115F (45C). 1. 2. 3. 4. Do not overcharge your phone. The unit may become hot under excessive use. Remove your phone once it is fully charged. Never charge your phone for more than 7 hours at a time. To reduce the risk of injury, close supervision is required when the product is used near children. 5. Do not expose the device to moisture. Do not use the device in excess of its 6. output rating. Overload outputs above the Do not use the device if damaged or 7. 8. explosion or risk of injury. Do not disassemble the device. For repairs, 9. Incorrect reassembly may result in a risk of 10. 11. 12. or temperatures above 104F (40C) may result in explosion. To ensure product safety, ensure that identical replacement parts. Attachments on the back of your phone can impede the effectiveness of the wireless charger, and lead to overheating. Please remove attachments from the phone before charging on this device. FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
(1)
(2)
*
Warning:
approved by the party responsible for compliance could void the users authority to operate the equipment. FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Made in China