M13 Device description Version 0.1 APR 7th 2009 Part 15.21 statement
" Change or Modifications that are not expressly approved by the manufacturer could void the user's authority to operate the equipment. Part 15.105 statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Part 15 Class B Compliance This device and its accessories comply with part15 of FCC rules. Operation is subject to the following two conditions:
(1) This device & its accessories may not cause harmful interference.
(2) This device & its accessories must accept any interference received, including interference that may cause undesired operation. 1.1 Feature Copyright Copyright 2009 LG Electronics Inc. All Rights Reserved. Though every care has been taken to ensure the accuracy of this document, LG Electronics Inc. cannot accept responsibility for any errors or omissions or for any loss occurred to any person, whether legal or natural, from acting, or refraining from action, as a result of the information contained herein. Information in this document is subject to change at any time without obligation to notify any person of such changes. LG Electronics Inc. may have patents or patent pending applications, trademarks copyrights or other intellectual property rights covering subject matter in this document. The furnishing of this document does not give the recipient or reader any license to these patents, trademarks copyrights or other intellectual property rights. No part of this document may be communicated, distributed, reproduced or transmitted in any form or by any means, electronic or mechanical or otherwise, for any purpose, without the prior written permission of LG Electronics Inc. The document is subject to revision without further notice. All brand names and product names mentioned in this document are trademarks or registered trademarks of their respective owners. 1.1. Feature Caution To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm (8 inches) between the equipment and the body must be maintained.
<UE> <User>
At least 20 cm (8 inches) About This Document Revision History 1.1. Feature Version Date Comment Author 0.1 2009-04-07 Initial Draft Sang Ha Park References 1 General Description 1.1. Feature 1.1 Feature 1.1 Feature This document describes briefly the board level operations, key features and the environment of the M13 Platform. The purpose of this platform is the verification of LG LTE ASIC, namely L1000, and the evaluation of LG UE system performance. The further details about the characteristics and functions of L1000 are available on other documents. M13 consists of a CDMA main board, a LTE sub board. Specification SW Date
<Table 1. M13 Device Feature>
LTE only 31-May-30 HW General Interface Spec. LTE USB 2.0 High Speed CDMA USB 2.0 Full Speed External port Micro USB 1 Port Standard(SW ver.) LTE 3GPP Rel. 8 (Dec. 2008) CDMA N/A Band support LTE 3GPP Band 13
(700 MHz Upper C block) CDMA N/A Main chipset LTE L1000 (by LGE) CDMA MSM6800A (by QCT) Max. Data rate LTE DL 50Mbps / UL 25Mbps
(Category2) GPS Battery CDMA N/A Not Support Support Remark Transmitter Tx Diversity LTE Not support Max. Tx Power Band Width LTE LTE 23 dBm 10MHz UE Antenna Selection will not be supported At antenna port 1.1. Feature Adaptive switching between downlink Transmit Diversity and SU MIMO Downloading tool for field upgrade through USB port LGE tool for LTE LTE only'
'LTE preferred'
'eHRPD only'
Modulation Method Receiver Rx Diversity MIMO Band width Modulation Method SW Interface Interface protocol LTE LTE LTE LTE LTE LTE Up to 16QAM Support 2x2 MIMO 10MHz Up to 64QAM USB Ethernet CDMA N/A USB Driver LTE 3 Ports (Data, DM, Control) CDMA 3 Ports (Data, DM, Control) Downloading Tool Support DM (Diagnostic Monitor) Support System selection Prefered system selection Support 'LTE only' mode Support System LTE only PRL/PLMN List LTE Support PLMN Authentication
Identity User Identity Module
(IMSI) CDMA N/A LTE Device CDMA N/A Authentication LTE Not Support CDMA N/A Numbering & Identities IP support IPv4/6 dual IP stack LTE NAI based upon the IMSI 11digit MDN Support for IPv4/6 (need to test with Network) DHCP CDMA LTE N/A N/A 1.1 Feature CDMA N/A IP Mobility LTE Proxy mobile IPv4/6 eHRPD N/A QoS QoS LTE Support IRAT handoff Active handoff CDMA Idle handoff IRAT measurement N/A N/A N/A N/A Mechani cal Mechanical Dimensions (W xD xH) 185 x 133.9 x 22.8 mm Non optimized handover Non optimized handover Weight Antenna 420g Internal Antenna (MIMO) 2 Mechanical description 2.1 Front / Rear / Side View 2.1 Front / Rear / Side View
<Fig 4-1. M13 Mechanical Part Top View>
<Fig 4-2. M13 Mechanical Part Bottom View>
<Fig 4-3. M13 Mechanical Part Side 1 View>
2.1. Front / Rear / Side View
<Fig 4-4. M13 Mechanical Part Side 2 View>
2.2 Dimension 2.2 Dimension M13 Mechanical dimension is 133.9 x 185 x 22.8mm. 2.2. Dimension 3 Functional description 3.1 Functional Key description 3.1 Functional Key description LTE trial device picture is below.
<Fig 5.1 LTE & eHRPD LTE Trial Product Picture>
This product has some key to operate LTE trial device. Send key
: This key is used to call. Clear key
: This key is used to erase character or number.
: This key is used to disconnect a call and stop to function. End key 3.2. External connector description 3.2 External connector description Our LTE Trail device has several external connectors. DC input jack connector: External Power source, 5V TA USB connector: USB Connect to Host (PC) SIM socket: for LTE Authentification 24Pin connector: For debug LTE Sub board DC input Jack USB cap SIM socket cap HW Reset key 24Pin connector for LTE Sub board debugging Earphone jack connector 3.3 External RF connector description 3.3 External RF connector description LTE MIMO ANT mobile SW LTE Main ANT mobile SW GPS ANT mobile SW CDMA ANT Mobile SW LTE Trial device has 4 external RF connectors in order to measure wired RF performance characteristic. It is configured that LTE ant part is two external ANT port; LTE main ANT mobile switch and LTE MIMO ANT mobile switch, and CDMA ANT mobile. If you want to test LTE RF performance, you can use this external ANT port. 3.4. Antenna description (LTE & CDMA) 3.4 Antenna description (LTE & CDMA) 3.4.1 CDMA Antenna description M13 Device LTE Antenna: Dual band, Single Feeding Antenna Type: Carrier & PIFA Directive: Omni-directiona Ant. : 1TX and 1RX CDMA 3D Gain: TX:--5.9dB, RX: -3.7dB USPCS 3D Gain: TX: -6.1dB, RX: -5.1dB Max Power: 2W (Maximum) Band Support 3.4.2 LTE Antenna description M13 Device LTE Antenna: MIMO Antenna Type: Carrier & PIFA Directive: Omni-directional LTE Band 13 Support: UL; 777~787(MHz), DL;746~768(MHz) Antenna Band: 740 ~ 800 (MHz) Max power: 2W(Maximum) Primary Ant. : 1TX and 1RX Secondary Ant.: 1RX 3D Primary Antenna Gain: -1.32dB(Average) 3D Secondary Antenna Gain: -1.34(Average) 3.5 External Power description 3.5 External Power description To operate and charge the battery, plug the AC Adapter into a standard wall outlet and connect it to the LTE trial device via the DC input jack Connector. External power supply is DC input jack or TA. This power supply specification is below. Input Voltage & Current Output Voltage & Current 3.6 Battery description 3.6 Battery description Our LTE Trial device has a two Battery. One is used for operating CDMA modem part, and another is used for operating LTE modem part. Battery Capacity for used in CDMA part is 1100mAh. But in order to operating fully LTE performance, it is need to larger battery capacity. And then we selected 2400mAh cylindrical battery. Total Battery capacity is 3600mAh If the batterys charge is completely run down, it takes 6 to 7 hours to fully recharge. But this battery capacity is not enough to operate LTE capability; you should external power supply, which is TA (Travel Adaptor). The mandatory power supply of the LTE UE is supplied by TA which is distributed by the LGE.
<Travel Adaptor>
<USB Cable>