FCC ID: 2AEVM1014697 Sharper Image ANC Headphone

IC: 21808-1014697 susceptible den compromettre le fonctionnement. 2Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est 1Lappareil ne doit pas produire de brouillage;

appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme undesired operation of the device. 2This device must accept any interference, including interference that may cause 1This device may not cause interference. Operation is subject to the following two conditions:

Innovation, Science and Economic Development Canadas licence-exempt RSS(s). This device contains licence-exempt transmitter(s)/receiver(s) that comply with splintered, cracked, or broken in any manner, discontinue use immediately. Thoroughly inspect earbuds and case before every use. If items appear worn, frayed, Do not expose to extreme temperatures or leave in direct sunlight. Charge only with the included charging case and cables. Always pay attention to your surroundings while using your earbuds. Do not use earbuds while driving. Listening to loud music for extended periods of time may damage hearing. Not a childrens item. Keep out of reach of children. SAFETY WARNINGS:

Keep these instructions for future reference. Recycle or dispose of battery according to federal, state, and local laws. used until the damage has been repaired. cord, plug, enclosure, and other parts. In the event of such damage, chargers must not be Battery chargers used with the product are to be regularly examined for damage to the Discontinue charging if battery becomes hot, swells, smokes, or gives off a strong odor. Charge on a non-flammable surface and keep away from flammable products. Allow battery to cool to room temperature before charging. Adult supervision is required while charging the battery. Rechargeable battery is only to be charged by an adult. Only charge using the provided charger, cable, and/or adapters. Keep away from flammable materials and direct sunlight. Never expose battery to extreme temperatures or moisture. Do not dismantle, crush, incinerate or short-circuit battery. There is a risk of fire and personal injury if battery is punctured, damaged, or misused. This product contains batteries that are non-replaceable. WARNINGS:

RECHARGEABLE BATTERY SOUNDHAVEN ANC earpads. To check legal marking (FCC ID and IC ID), simply remove the FCC ID: 2AEVM1014697 the users authority to operate the equipment. approved by the party responsible for compliance could void Warning: Changes or modifications to this unit not expressly for help. Consult the dealer or an experienced radio/TV technician from that to which the receiver is connected. Connect the equipment into an outlet on a circuit different Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. following measures:

to correct the interference by one or more of the turning the equipment off and on, the user is encouraged to try to radio or television reception, which can be determined by installation. If this equipment does cause harmful interference guarantee that interference will not occur in a particular interference to radio communications. However, there is no accordance with the instructions, may cause harmful radio frequency energy and, if not installed and used in installation. This equipment generates, uses and can radiate protection against harmful interference in a residential the FCC Rules. These limits are designed to provide reasonable with the limits for a Class B digital device, pursuant to part 15 of Note: This equipment has been tested and found to comply may cause undesired operation. accept any interference received, including interference that not cause harmful interference, and (2) this device must is subject to the following two conditions: (1) this device may This device complies with part 15 of the FCC Rules. Operation FCC STATEMENT CONGRATULATIONS ON YOUR PURCHASE OF THE SOUNDHAVEN ANC. Please read all instructions and warnings prior to use. Keep this manual as it contains important information for future reference. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. Computers, tablets, Smart Phones, and music players must have built-in BLUETOOTH wireless technology to connect. This product is not affiliated with or endorsed by any of the above mentioned, referenced or pictured trademarks, companies or devices. SHARPER IMAGE NAME AND LOGOS (INCLUDING THE 77 LOGO, TOMORROWS TOMORROW) ARE TRADEMARKS OR REGISTERED TRADEMARKS. DISTRIBUTED BY AND 2021 MERCHSOURCE, LLC. IRVINE, CA 92618. ALL RIGHTS RESERVED. FOR CUSTOMER SUPPORT, PLEASE CALL 1-800-374-2744. Printed in China. CONTENTS SoundHaven ANC headphones Carrying case 3.5mm cable USB-C charging cable GETTING STARTED Voice Assistant Bluetooth status LED 3.5mm Port Power On/Off USB-C Port Touch Control Call button Charging LED CHARGING

(not included). 1. Connect the USB-C charging cable to a USB power adapter 2. Connect the other end of the USB-C charging cable to the USB-C port on the right side of the headphones. The LED will be orange when charging and green when fully charged. ADJUSTING Adjust the headphones by carefully pulling or pushing the earcups in or out from the headband until you find the fit that feels most comfortable to you. side of the headphones (Figure A). 2. To cancel a call, press the call button again. 3. To reject a call, press and hold the call button for 1 second. 4. To mute the call quickly double tap the touch control on the right side of headphones. 5. To end the call, press the call button. 6. To redial the last number called, press the call button twice. MUSIC FUNCTIONS 1. To play or pause music, tap the touch control on the right side of the headphones (Figure B). 2. To increase the volume, slide your finger around the touch control clockwise (Figure C). control counterclockwise (Figure D). A. B. C. D. HOW TO USE POWER 1. To power on the headphones, press and hold the power button for 5 seconds. The LED will glow blue and a power notification will play. 2. To turn off the headphones, press and hold the power button for 5 seconds. The LED will turn white and then the headphones will turn off. WIRELESS PAIRING 1. Power on the headphones to automatically enter pairing mode the first time or automatically reconnect to the last paired device. 2. Enable Bluetooth functionality on your compatible device and select SOUNDHAVEN ANC from the menu. A connected notificationon will play when the headphones have been successfully paired. 3. To manually disconnect, turn off Bluetooth on your onnected device or remove the headphones from the device list. 4. To connect to a new device, turn off the headphones and then hold the power button for 8 seconds. the touch panel on the left side of the headphone. 2. When ANC is ON, double tap the touch panel on the left side of the headphone to cycle through the 4 ANC mode. Mode 1: Blocks noise expected in airplane cabins Mode 2: Blocks noise with bass and low frequency Mode 3: Blocks noise in outdoor and windy environments Mode 4: Blocks noise associated with offices and restaurants 3. To turn on or turn off transparency mode, press and hold the control panel for 2 seconds. Transparency Mode: Allows you to hear others speak without needing to remove your headphones. OTHER FUNCTIONS button on the left side of the headphones. 2. For wired audio, plug the 3.5mm cable (included) into the 3.5mm port on the headphones. STORAGE in use. 1. Always store the headphones in the included case when not 2. To fit the headphones into the case, adjust the headband to the smallest size and swivel the earcups flat. CALL FUNCTIONS ACTIVE NOISE CANCELING 1. To answer an incoming call, press the call button on the right 1. To turn ON or OFF ANC (Active Noise Canceling), single Tap 3. To decrease the volume, slide your finger around the touch 1. To activate your voice assistant, press the voice assistant

Pantone cool Gray 11U 3.285mm 6.722mm

=4mm

=4mm

=4mm

=4mm 45 22mm 1.43mm

=7.16mm Sharperimage Batch Code:

60060A22158 QC A-Z26 AB C 15.6mm 9.54mm 5mm 14mm 4.71mm 21.52mm

MerchSource, LLC. Attention: Certification reviewer RE:

Request for Confidentiality FCC ID: 2AEVM1014697 To Whom It May Concern:

Permanent Confidentiality [Complete this section if permanent confidentiality is requested]

Request to withhold permanently from public review certain portions of the application for equipment certification for the referenced FCC identifiers. This request for confidentiality is made pursuant to 47 CFR 0.457(d) and 0.459 of the FCC Rules. In particular, the following sections of the application are to be kept permanently confidential:

[Select one or more of items below, as appropriate]

Schematics Block Diagrams Operational Description Tune-up Procedure Parts List Internal Photos (see note) Users Manual (see note) Note 1: Internal Photos may be held confidential 1) if the circuit board or internal components are not accessible to users. For example, it is acceptable if the circuit board is enclosed in epoxy. 2) Also, it is acceptable if the device is not accessible to the public, for example, a device mounted on the top of a large tower (or in a fenced enclosure) such that it is only serviceable by professional designated technicians under a Non-Disclosure Agreement (NDA). All sales for these devices must be under a NDA restricting the disclosure of the propriety information, including internal photos. Users Manual may be held confidential only when the manual contains proprietary technical information intended for professional technicians obligated under a NDA. All sales and distribution of the users manual must be under a NDA that restricts the disclosure of the information. In the application cover letter requesting permanent confidentiality the following additional description and the NDA exhibit is required:

1. Describe in detail how internal photos and/or users manual information are controlled to prevent them from becoming public or disclosed to unauthorized persons. 2. Describe how public access is restricted for products serviceable by professional designated technicians. 3. A statement that all sales of the non-consumer device will be under a NDA to include third party sales and that the final user of the device is subject to the NDA. 4. Provide an example of the NDA between the grantee and a purchaser. The request for confidentiality must Note 2: For scanning receiver, the schematics, block diagrams, operational description, tune-up procedure, parts list and internal photos are always held permanently confidential. Short-term Confidentiality [Complete this section if short-term confidentiality is requested]

Request to withhold from public review for a period of [please enter 1 to 180] days from the date of the Grant of Equipment Authorization and prior to marketing, certain portions of the application for equipment certification for the referenced FCC identifiers. This request for confidentiality is made pursuant to 47 CFR 0.457(d) and 0.459 of the FCC Rules. In particular, the following sections of the application are to be kept short-term confidential for a period above from the date of the grant

[Select one or more of items below that are not selected in the list above, as appropriate]

Schematics Block diagrams Operational Description Tune-up Procedure 1(2) Parts List Test Setup Photos External Photos Internal Photos Users Manual Rationale for request for confidentiality:

We have invested considerable time and materials in research and development to produce the referenced product. Permanent confidentiality: Disclosure of the permanently confidential portions of this application to competitors would not only give them significant competitive advantages in developing similar products, but would also disclose successful implementation of unpublished, leading edge technology developed by us. Short-term confidentiality: Disclosure of the short-term confidential portions of this application during the period of importation and/or distribution would reveal key aspects of proprietary technology to competitors and diminish the value of our investment in research and development. If you have questions or need further information, please contact the undersigned. Sincerely, _________________ Shirley Luo Sr. Compliance Manager 20 June 2022 2(2)

Limited Agency Agreement

( MerchSource, LLC. ) FCC ID: 2AEVM1014697

[20 June 2022]

Federal Communications Commission 445 12th Street SW Washington, DC 20554 Subject:

To Whom It May Concern:

We, ( MerchSource, LLC. ), hereby authorized Intertek Testing Services to act as our Agent for the purpose of preparing application for FCC ID number (2AEVM1014697) under all applicable parts of the FCC rules and regulations. The effective date of this limited agency agreement is (20 June 2022). The Limited Agency Agreement expires on (20 June 2023), unless sooner terminated or extended by written notice to Intertek Testing Services and the Federal Communications Commission. This is to advise that we are in full compliance with the Anti-Drug Abuse Act. The applicant is not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 U.S.C. 862, and no party to the application is subject to a denial of federal benefits pursuant to that section. If you have any questions or comments, please do not hesitate to contact me. Sincerely,

[Shirley Luo]

Sr. Compliance Manager