OFF POSSITION: OFF OFF POSSITION: OFF MIDDLE POSITION:
MIDDLE POSITION:
RC ON (TURNS ON THE RC FUNCTION) RC ON (TURNS ON THE RC FUNCTION) AUTO POSITION:
AUTO POSITION:
RC OFF, TRAIN RUNS CONTINUOUSLY RC OFF, TRAIN RUNS CONTINUOUSLY AUTO OFF Mindscope Products Inc PO Box 9525 Glendale, CA 91226 TEL (626)398-2000 Made in Shantou, Guangdong, China Date of Manufacture: 06/06/2012 Batch #: 060612 Item #: TTT147 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation TIGHTEN SCREW TO TIGHTEN SCREW TO SECURE BATTERY COVER SECURE BATTERY COVER 2 AA batteries (not included) insert in compartment. reverse NOT forward A A A A A A A A A AAA AAA AAA USE 3 AAA SIZE BATTERIES (NOT INCLUDED 27MHZ Remote Control requires 3 AAA batteries (not included) TOTAL OF 3AAA + 2AA BATTERIES REQUIRED (NOT INCLUDED) CAUTION:
Remove old batteries and replace with new batteries. Be sure to insert batteries correctly according to (+) and (-) symbols located in the battery compartment. Be sure to insert batteries correctly with adult supervision and always follow the toy and battery manufacturer's instructions. Do not mix old and new batteries. Do not mix alkaline, standard (carbo-zine), or rechargeable (nickel-cadmium) batteries. Rechargeable batteries are to be removed from the toy before being charged. Non-rechargeable batteries are not to be recharged. Rechargeable batteries are only to be charged under adult supervision. Only batteries of the same equivalent type as recommended are to be used. The supply terminals are not to be short-circuited. Always remove weak or dead batteries from the product. Remove batteries if the product will be stored for an extended period of time. Please retain these instructions for future reference. Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. 6 03625 76022 1