UserUser Manual Manual MobileMobile Phone Phone ModelModelVFDVFD 321, 321, that this Hereby, MOBILE Hereby, declares that declares MOBILE LIMITED LIMITED Phone isis inin this MobileMobile Phone compliance withwith thethe essential essential compliance other relevant requirements andand other relevant requirements Directive 2014/53/EU. provisions ofof Directive 2014/53/EU. provisions 1 Know your phone 2 SIM/SD card installation Power offoff mobile. 1.1. Power mobile. Refer toto thethe following 2.2. Refer installation. installation. following picture picture forfor SIMSIM // SDSD cardcard 3 device using using aa charger using aa USBUSB cable charger oror byby connecting connecting
(comes withwith thethe cable (comes your device computer using Charging the phone YouYou cancan charge charge your itit toto thethe computer phone). phone). 1.1. Please 2.2. UseUse onlyonly original remind thethe front original charger Please remind front andand backback ofof thethe plug. plug. charger andand cables. cables. Other cables maymay damage cables invalidate your invalidate damage thethe device phone warranty. your phone warranty. device oror your Other chargers chargers oror device. ThisThis willwill your device. 4 Operating Frequency Band (RF) 869-894 MHz(RX), 925.0960.0MHz(RX) GSM850:824-849 MHz(TX), EGSM900:880.0915.0MHz(TX), DCS 1800: 1710.01785.0MHz (TX), 1805.01880.0 MHz (RX) PCS 1900: 1850.01910.0MHz (TX), 1930.01990.0MHz (RX) WCDMA BAND1: 1920-1980MHz (TX), 2110-2170MHz (RX) WCDMA BAND8: 880-915MHz (TX), 925-960MHz (RX) Bluetooth: 2402-2480MHz (TX/RX) WIFI: 2412-2462MHz (TX/RX) GPS:1575.42MHz FM87.5MHz-108MHz(RX) Modulation mode GMSK (GSM850/GSM900/DCS/PCS) WCDMA Uplink BPSK/QPSK/16QAM WCDMA Downlink BPSK/QPSK /16QAM/64QAM GFSK//4-DQPSK/ 8-DPSK (Bluetooth) BPSK/QPSK/16QAM/64QAM/DSSS/OFDM/ CCK (WIFI b/g/n) BPSK/QPSK (GPS) 5 Max Output Power Item GSM850/GSM900 PCS1800/DCS1900 WCDMA900/WCDMA2100 BT 802.11b 802.11g 802.11n 20M 802.11n 40M Max Output Power(dBm) 33.5 30.5 23 5.5 15.5 13.5 12.5 11 6 CAUTION 1. Use careful with the earphone maybe excessive sound pressure from earphones and headphones can cause hearing loss. 2. Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to the instructions. 3. The product shall only be connected to a USB interface of version USB2.0. 4. Adapter shall be installed near the equipment and shall be easily accessible. 5. EUT Temperature: -20+60. 6. Charger1:A31A-050100U-EU1 Charger2:A31A-050100U-EU1 Charger3:WUK550mA5V00 Charger4:TUUK050055 Charger5:TUAU050055 7. The device complies with RF specifications when the device used at 5mm from your body. 8. To prevent possible hearing damage, do not listen at high volume levels for long periods. 9. Earphone and USB cable are shielded. Hereby, vodafone, declares that this device (VFD 321)is in compliance with the essential requirements and other relevant provisions of Directive 2014 / 53 / EU. The full text of the EU declaration of conformity is available at the following internet address: www.vodafone.com 7 FCCRegulations 15C This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must including accept any interference received, interference undesired operation. that may cause Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(15B)This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. installation. These limits are designed to provide reasonable interference in a protection against harmful residential This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. guarantee However, that in a particular interference will not occur this equipment does cause installation. harmful television reception, which can be determined by turning interference to radio or there no is If 8 the equipment off and on, is encouraged to try to correct the interference by one or more of the following measures:
the user Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RadioFrequency(RF)Energy This phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. level in all During SAR testing, this device was set to transmit at its highest certified power tested frequency bands, and placed in positions that simulate RF exposure in usage against the head with no separation, and near the body with the separation of 10 mm. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the phone is 9 designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. The exposure standard for wireless devices employing a unit of measurement is known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. This device is complied with SAR for general population
/uncontrolled exposure limits in ANSI/IEEE C95.1-1992 in accordance with the measurement methods and procedures specified in IEEE1528. tested been had and The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: QPN-VFD321 For this device, the highest reported SAR value for usage against the head is1.133W/kg, and for usage near the body is 1.165W/kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirements. SAR compliance for body-worn operation is based on a 10 separation distance of 10 mm between the unit and the human body. Carry this device at least 10 mm away from your body to ensure RF exposure level compliant or to the reported level. To support body-worn operation, choose the belt clips or holsters, which do not contain metallic components, to maintain a separation of 10 mm between this device and your body. lower RF exposure compliance with any body-worn accessory, which contains metal, was not tested and certified, and using such body-worn accessory should be avoided. 11