WRELESS CHARGER Car Mount USER MANUAL Thanks for choosing our Wireless Charger!
Please read the user manual carefully, and keep it for future reference. For any inquires or comments concerning our products, please contact us and we will respond to you ASAP. Instruction Operation Select an appropriate position according to the width of the vent slat. Dual- position claw to fit thick or thin vent slat Plug in the charging cable, the indicator lights will flash red and blue once simultaneously, and then go off Indicator Lights Plugged in Standby Charging Exception Fully charged iphone The indicator lights (blue and red) flash once simultaneously and then go off. The indicator lights go off. The blue indicator light stays on. The red indicator light flashes. The indicator lights go off for Samsung The blue indicator light stays on for iPhone Place Your Phone & Align Your Charging Center
&
*To align the charging center, the length between the telescopic support and the corresponding Model Mark should be extended.
*
*Press the Release button to release the clamp.
*
*Place your phone on the holder and press the clamp to fix the phone tightly.
*
Attention 1.Please confirm whether your phone supports wireless charging mode. 2.Please adjust the charging position carefully and fix the smartphone firmly, or it will disturb the normal charging if your car jolts. 3.It may occur occasional intermittent charging or serious heating due to the inaccurate position of phone receiver coil and wireless charging. Please try to readjust the telescopic support to carry out the alignment. 4.Charge the product at temperatures below 50. 5.An extreme thick protective casing or metal material on your smartphone will influence the alignment and charging, so remove it before using (The casing thickness should be within 4 mm). 6.Do not charge via the computers USB port for its voltage is too low to support wireless charging. 7.Charge via a 5 V/ 2 A QC car charger to ensure the optimal charging efficiency (5 W). 8. If the adapter is of QC 2.0 or above, the charging efficiency can reach 7.5 W or 10 W for your phone. 1. 2. 3. 4. 50 5. 4mm 6. USB USB 7. 5V / 2A 5W 8. QC2.0 7.5W 10W Correct Disposal of This Product
(Waste Electrical& Electronic Equipment) This Marking shown on the product or its literature, indicate that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household user should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contact. This product should not be mixed with other commercial wastes for disposal. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.