DOORBELL KEY INSTALLATION 1. O P E N T H E B AT T E R Y D O O R , I N S E R T O N E 9 V O LT (6F22) WIRELESS DOORBELL INSTALLATION INSTRUCTION BATTER Y INT O THE B ATTER Y COMPAR TMENT WITH CORRECT POLARIT Y. 2. CLOSE THE B ATTER Y DOOR . 3. CHOOSE T HE PLACE T O M OUNT THE D OORBELL KE Y. 4. USE PENCIL T O MARK T HE SCREW H OLES FOR T HE BELL KE Y.
( S HOWN IN FIG . 1) 5. REMOVE THE BELL KEY AND DRILL THE R EQUIRED H OLES . 6. SECURE THE BELL KEY IN PLACE WITH T WO SCREWS . OPERATION:PRESS THE BELL KEY,ITS RED LED LIGHTS ON AND IT STARTS TO SEND WIRELESS SIGNAL. THE RECEIVER CHIME CAN SOUND MUSIC UNTIL THE BELL KEY STOPS SENDING WIRELESS SIGNAL AFTER RELEASING THE BELL KEY AND ITS RED LED TURNNING OFF. HINTS : IF WHEN THE BELL KEY IS PRESSED AND T HE RED L IGHT DOES NOT G O O N , THAT INDICATES T HE KEY ?S BATTER Y IS LOW. REPLACE WITH A NEW B ATTER Y THE TWO RECTANGLE ADHESIVES ARE TO BE PLACED ON THE FRONT OF DOORBELL RECEIVER TO LOWER THE SOUND VOLUME IF NEEDED CHANGE T HE BATTER Y 1. REMOVE THE BELL KEY FROM WHERE I T I S M OUNTED WITH A S CREW DRIVER . 2. OPEN THE B ATTER Y DOOR . ( S HOWN IN FIG . 1) 3. INSER T A NEW B ATTER Y. 4. SECURE THE BELL KEY BACK I NT O P OSITION . DOORBELL RECEIVER I NSTA LLATION 1. HOLD THE D OORBELL RECEIVER F ROM T HE PLASTIC CASING CAREFULLY. DO NOT T OUCH THE METAL PA R T S .( S HOWN IN FIG
.2) 2. PLUG THE D OORBELL RECEIVER I NT O A NY A.C. (110 VOLT ) OUTLET U P T O 50 FEET AWAY FROM DOORBELL KE Y. 3. PLUG ANOTHER D OORBELL RECEIVER I NT O A NOTHER A.C.
(110 VOLT ) OUTLET UP T O 50 FEET AWAY FROM DOORBELL KE Y. C. No. : Pe9202 INST. VER.0 PRINTED IN CHINA MAP 2009/10 RED LED BATTERY DOOR FIG. 1 METAL PARTS PLASTIC CASING FIG. 2 FCC Statement:
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital, pursuant to Part 15 or the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may casue harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--- Reorient or relocate the receiving antenna.
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--- Consult the dealer or an experienced radio/ TV technician for help.