Compliance P 5 & PX7 Payment Terminal X PAX TECHNOLOGY INC. PAX TECHNOLOGY INC. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures. FCC Regulations FCC Regulations 1 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF Exposure Information RF Exposure Information This device meets the governments requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. 2 0 0 3 1 2 0 0 0 0 0 0 2 3 0 This document is provided to you for informational purposes only. All features and specifications are subject to change without notice. PAX's name and PAX's logo are registered trademarks of PAX Technology Inc. All rights reserved. PAX Technology Inc. 4901 Belfort Road, Suite 130 Jacksonville, FL 32256, USA T: 877-859-0099 W: www.pax.us E: sales@pax.us PAX TECHNOLOGY INC. IC Notice IC Notice This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de la classe B est conforme la norme NMB-003 du Canada. IC Radiation Exposure Statement IC Radiation Exposure Statement 4 This EUT is very low power and complies with IC CNR-102 exemption requirements. Ce MAE est trs faible puissance et de la conformit aux exigences d'exemption IC CNR-102. PX7 FCC IDV5PPX7RF IC11689A-PX7RF PowerPower x x 5 If a power supply was not shipped with the P terminal or if there is not an immediately available power supply to use with the P terminal, use the following guidelines when selecting and using a suitable power supply:
Must use PAX Power Supply (Material No. 200310110000070) and PAX Power Cord (Material No. 200311020000023), or Must use a suitable safety listed power supply, output rated 9Vdc 1A or greater and must be a certified Limited Power Source marked LPS. When so powered, this device is intended to be connected only to Power over Ethernet (PoE) networks that are not routed to the outside plant. UL 60950 RoHS PCI PTS 4.x PCI PA-DSS
( +
-)