SAFETY AND REGULATORY INFORMATION ADVANCED TYRE INTEGRATED SENSOR Safety messages WARNING Indicates a hazardous situation which, if not avoided, may cause death or serious injury. The Sensor is a radio device with wireless interface. The Sensor is equipped with a Bluetooth interface which operates in the 2.4 GHz ISM band. (2.4000 - 2.4835 GHz). It meets the requirements for low-energy Bluetooth modules which support Bluetooth Low Energy (BLE) 5.0. General Safety Warnings The tyre is equipped with a Pirelli Sensor Node (PSN) sensor (hereinafter referred to as the Sensor), a radio device equipped with a lithium battery which is neither replaceable nor rechargeable. When using the tyre, the specified conditions of use for the tyre itself must be respected. The safety and regulatory information for the Sensor is given below. Regulatory Information - FCC Sensor Name: Cyber Pirelli Sensor Node. Model Name PSN-09S FCC ID: 2ANX7CPSN1 Compliance with Part 15 of the FCC Rules The equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
i. The equipment may not cause harmful interference, and ii. The equipment must accept any interference received, including interference that may cause undesired operation. Compliance with Class B digital devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the User is encouraged to try to correct the interference by one of the following measures:
i. Reorient or relocate the receiving antenna. ii. Increase the separation between the equipment and receiver. iii. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. iv. Consult the dealer or an experienced radio/TV technician for help. FCC Caution i. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. ii. Co-location of this transmitter with other transmitters that operate simultaneously is required to be evaluated using the FCC multi-transmitter procedures. Radiation Exposure This equipment complies with portable FCC radio frequency exposure limits set forth for an uncontrolled environment. Wireless Interface Battery WARNING Improper use of the tyres and the Sensors can cause harm to human health and the environment. Disassembly of the Sensor and its battery by the user is prohibited. The lithium batteries inside the Sensors contain flammable material. The substances contained in the battery are harmful and can have a negative impact on human health and the environment. Improper use of lithium batteries can cause overheating which could lead to a fire or explosion, with the risk of personal injury and/or environmental damage. To avoid such incidents during use/handling of the batteries, ensure you observe the following precautions:
Do not dispose of the batteries in fire Do not heat the batteries or expose them to sources of heat. Do not disassemble the batteries. In the event of improper use of and/or accidental damage to the battery, which causes the contents to leak out, follow the precautions outlined below. Inhalation: the fumes can cause respiratory irritation; leave the area and go to a cool and well-ventilated location. Contact with skin: wash immediately with plenty of water and seek medical attention, particularly if any irritation persists. Contact with eyes: wash immediately with plenty of water for at least 15 minutes. Contact with mouth: rinse immediately with plenty of water and seek medical attention. In the event of a fault with the sensor and possible accidental damage to the battery, which causes the contents to leak out, tyre dealers are recommended to use appropriate personal protective equipment (PPE) when removing the device in order to avoid the issues outlined above. Waste Sorting and Recycling of the Sensors It is the installer's responsibility to dispose of the Sensors in accordance with applicable legislation. Incorrect disposal of materials can lead to penalties in accordance with applicable legislation. Separating waste and recycling contributes to the preservation of natural resources and ensures correct recovery of materials, helping protect human health and the environment. Sensors on worn tyres must be removed from the tyre and disposed of in accordance with applicable legislation. For further information on the methods and locations for disposing of used Sensors, contact Pirelli at trackadrenaline.support@pirelli.com. Disposal requirements The crossed-out wheelie bin symbol on the Sensors and their packaging indicates that the Sensors and the batteries contained in them must be disposed of separately, and NOT with unsorted urban waste. Pirelli Tire LLC 100 Pirelli Drive, Rome, GA 30161-7000 USA www.pirelli.com - 2019 Pirelli Tire LLC