TECHNICAL SPECIFICATIONS DIMENSIONS 85x115x17mm 85x126x26mm WEIGHT 137g (4,8 ounces) 235g (8,28 ounces) BATTERY CAPACITY 5600 mAh BATTERY LIFE 24 hours 10000 mAh 48 hours Qi WIRELESS CHARGER NO COMMUNICATION SYSTEM TD-LTE/LTE Support FDD/WCDMA/GSM with iPhone 8/X YES (Compatible and most Android phones) Output 5V 1A TD-LTE/LTE Support FDD/WCDMA/GSM TD-LTE frequencies B41 B41 FDD LTE frequencies B2/B4/B5/B7
/B12/B17 B2/B4/B5/B7
/B12/B17 WCDMA frequencies B2/B5 B2/B5 GSM frequencies 850/1900Mhz 850/1900Mhz TD-LTE LTE FDD Wi-Fi PROTOCOL SIM CARD USB input USB output Cat4, up to 112Mb/s DL and 17Mb/
s UL Cat4, up to 112Mb/s DL and 17Mb/s UL Cat4, up to 150Mb/s DL and 50Mb/s UL Cat4, up to 150Mb/s DL and 50Mb/s UL IEEE 802.11 b/g/n/ac(*ac Support for receiving only), repeater up to 150 Mb/s IEEE 802.11 b/g/n/ac(*ac Support for receiving only), repeater 150 Mb/s up to 1 Soft-SIM SIM slot(Build-in)
(Embedded) 1 Standard 1 Soft-SIM Standard SIM slot(Build-in)
(Embedded) 1 USB type-C, Maximum current 1.65A 5V USB type-C, Maximum current 5V 1.65A USB output port (Power Bank) max current 5V 1.5A USB output port (Power Bank) max current 5V 1.5A FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. SAR Information Statement The product is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted with the product transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the product while operating can be well below the maximum value. This is because the product is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before a product model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model product when tested for use worn on the body, as described in this user guide, when properly worn on the body is 1.140W/kg.
(Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). While there may be differences between the SAR levels of various product and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model product with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model product is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on. FCC ID: 2AUKJ-POWER Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at https://www.ctia.org/ In the United States and Canada, the SAR limit is 1.6 watts/kg (W/kg) averaged over onegram of tissue. The standard incorporates a sub-stantial margin of safety to give additional protectionfor the public and to account for any variations in measurements. Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 0mm is used between the users body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.