Ponnk=\pine
(Hote to Aduits ) To ensure that the child's play is both safe and fun, please review all operating instructions and safety rules with your child.
( Battery and Antenna Installation - Transmitter and Vehicle ) Install one 9V battery with Tighten battery door with Tighten the antenna into polarity (+/-) as shown inside a Philips head screwdriver the transmitter. battery compartment. (not included). Install 5 AA batteries with polarity (+/-) Or, unlock and take out the battery Tighten battery door with a Philips as shown inside battery compartment compartment, and then install one 6V head screwdriver (not included). and then turn the locker to lock the battery pack with direction as shown battery compartment. on battery pack.
( Battery Safety Information ) Batteries may leak fluids that can cause damage to your toy. To avoid battery leakage:
- Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
- Insert batteries as indicated inside the battery compartment.
- Remove batteries during long periods of non-use. Always remove exhausted batteries from the toy.
- Do not dispose of batteries in a fire. The batteries may explode or leak.
- Never short-circuit the battery terminals.
- Use only batteries that are the same or equivalent of those that are required on the box package.
- Do not charge non-rechargeable batteries.
- Remove rechargeable batteries from the toy before charging.
- lf rechargeable batteries are used, they should be charged according to manufacturer's specifications and under adult supervision.
( Battery Performance Note ) For best performance, use alkaline batteries. Battery life will vary according to brand.
( Transmitter and Vehicle Operation ) LEVER If the car does not runina LED
| straight line, adjust the angle with this lever. ON/OFF |
Please make sure the power switch is the ON position FORWARD/ \
when you operate, and OFF BACKWARD position when not in use. JOYSTICK LEFT/RIGHT JOYSTICK
(Safety Tins )
* NEVER operate your vehicle on the street, thru water, sand, snow, thick carpet, or in the rain. If your vehicle gets wet, discontinue use until completely dry. DO NOT pick up vehicle while in motion. DO NOT store either unit near a source of heat or in direct sunlight for extended period. DO NOT operate the vehicle on the table top or other elevated surfaces.
* Keep fingers, hair and loose clothing away from the wheels.
* Adult supervision is recommended when this vehicle is being operated.
* AVOID running vehicle into objects.
* To avoid accidental operation, leave the power switch in the OFF position and remove all batteries when not in use.
(Quick Tins ) When your vehicle begins to lose performance, power or function, it may be time to replace the batteries. Radio interference may cause your vehicle to run poorly. In the event of interference, you may need to operate the vehicle in another location. Your vehicle's performance may vary depending on the driving surface. Point your transmitter antenna up, not downward toward your vehicle. If your vehicle gets too far away, it won't work properly. Smart Circuitry lf your vehicle gets stalled or stuck during play, a special circuit will cut power to protect it. Release your transmitter and wait 1-2 minutes (reposition you vehicle if necessary), and the vehicle will be ready to operate again. Modifications are not authorized by the manufacturer and may void users authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
@, 2006 ProMarkCo, Limited 5201 Village Parkway, Suite 301
& e Rogers, Arkansas 72758
@ = MADE & PRINTED IN CHINA 1 BADD RIDE 1:18 RC Instruction sheet Front Size: 210 x 285 mm
| 1 BADD RIDE 1:18 RC Instruction sheet Back Size: 210 x 285 mm Date: 27/08/05