submitted | available | document details (if available) | source link |
---|---|---|---|
November 29 2019 | November 29 2019 | Adobe Acrobat 10.1 Image Conversion Plug-in |
various | User Manual | Users Manual | 4.84 MiB | November 29 2019 |
STUNT DRIFT VEHICLE Instruction Manual Batteries and Charging Battery installatio
.W, ASL
. Loosen the screw in the battery compartment door with a Phillips screwdriver. Install 2 x 1.5 V AA batteries with correct polarity (+/-) as shown inside the battery compartment. Replace the battery door and tighten the screw. n for transmitter Battery Safety Information
. Battery requirement: vehicle requires 1 x 7.4V 1400mAh rechargeable battery pack; transmitter requires 2 x 1.5 V AA non-rechargeable batteries. Install and remove battery properly. DO NOT recharge non-rechargeable batteries. DO NOT mix old and new batteries or different types of batteries. 5. Use only batteries of the same or equivalent type as recommended. Insert batteries with correct polarity. Always remove exhausted batteries from the toy. Rechargeable batteries are only to be charged under adult supervision. Remove rechargeable batteries from the toy before charging. 10. DO NOT short-circuit the supply terminals.
i y Note:
Only use chargers specifically designed to charge the included vehicle battery. 1. Loosen the screw and remove the battery door. Remove the exhausted battery pack and install a fully charged one, making sure the battery connected with correct polarity
(+/-). Replace the battery door and tighten the screw. 2. Insert the battery pack into the USB charger, then plug the charger into a USB port. Transmitter Control Nose drifts left Turn left/right 45 left-front drifting Dance i ;
Horn S an Left slide SSM\\_*
45 left-rear drifting Tail drifts left
] + _Nose drifts right
| Type rorwarsbacewars 45 right-front
\ | HES drifting ar yf Demo 2 Tp Program
) Hy
: SA right side C - L 45 right-rear drifting Body twist Tail drifts right PROBLEM CAUSE SOLUTION
. Batteries are installed incorrectly. 1. Check that the batteries are installed with correct polarity (+/-) as shown inside the battery compartment. The battery is low. 2. Replace new batteries. Transmitter does not work
. Vehicle is out of range of transmitter. 3. Ensure the distance of remote control within 30 meters, point transmitter at the vehicle. Fail to link transmitter with vehicle. 4. Remove and reinstall the batteries to the transmitter. Re-set the vehicle OFF to ON. Move the sticks on the transmitter to re-link transmitter and vehicle. Power switch is OFF. 1. Make sure the switch is in ON position. Fail to connect the battery pack to the vehicle with correct polarity. 2. Check that the battery pack is connected to the vehicle with correct polarity. The battery is low. Vehicle does 3. Recharge the rechargeable battery pack, or replace with a fully charged one. not work properly
. Voices and lights of the vehicle become faint. 4. Recharge the rechargeable battery pack, or replace with a fully charged one. Fail to link transmitter with vehicle. FCC ID : 2AT4G11616 5. Remove and re-install the batteries to the transmitter. Re-set the vehicle OFF to ON. Move the sticks on the transmitter to re-link transmitter and vehicle. 1. Forward/backward Push the right stick up to run forward and down to run backward. Push and hold the right stick up/down will make the vehicle keep driving forward/backward. Nose drifts left 4. Nose drifts left Press the Nose Drifts Left button to make the vehicles nose drift to the left. Press and hold this button will make the nose keep drifting left. Tail drifts right T. Tail drifts right Press the Tail Drifts Right button to make the vehicles tail drift to the right. Press and hold this button will make the tail keep drifting right. 45 left-rear drifting 10. 45 left-rear drifting Press the 45 Left-Rear Drifting button to make the vehicle drift to the left-rear at an angle of 45 degrees. Press and hold this button will make the vehicle keep drifting to the left-rear at an angle of 45 degrees. Right slide 13. Right slide Press the Right Slide button to make the vehicle slide to the right. Press and hold this button will make the vehicle keep sliding to the right. Press the Horn button to play a car horn noise. Hold button for 3 seconds to turn off volume. QIANKUN Power ON: Turn on the vehicle and then the transmitter. The light on transmitter will turn off to indicate the transmitter and the vehicle is linked. Remote control distance: more than 20 meters. Operating time: approx. 20-30 minutes with fully charged battery. Note:
2. Turn left/right Push the left stick to the left to turn left and to the right to turn right. Push and hold the left stick to the left/right will make the vehicle keep turning left/right. Nose drifts right 5. Nose drifts right Press the Nose Drifts Right button to make the vehicles nose drift to the right. Press and hold this button will make the nose keep drifting right. 8. 45 left-front drifting Press the 45 Left-Front Drifting button to make the vehicle drift to the left-front at an angle of 45 degrees. Press and hold this button will make the vehicle keep drifting to the left-front at an angle of 45 degrees. 45 right-rear drifting 11. 45 right-rear drifting Press the 45 Right-Rear Drifting button to make the vehicle drift to the right-rear at an angle of 45 degrees. Press and hold this button will make the vehicle keep drifting to the right-rear at an angle of 45 degrees. 14. Dance Press the Dance button, the vehicle will play music and begin to dance. Press the Dance button again to play the next song. There are 3 songs in all. 17. Program Execute 4 Always switch vehicle OFF and remove the battery when not in use to avoid reducing the life of the battery. Body twist 3. Body twist Press the Change button once to lower the vehicle body. Press the Change button again will make the vehicle return to normal height. Tail drifts left 6. Tail drifts left Press the Tail Drifts Left button to make the vehicles tail drift to the left. Press and hold this button will make the nose keep drifting left. 45 right-front drifting 9. 45 right-front drifting Press the 45 Right-Front Drifting button to make the vehicle drift to the right-front at an angle of 45 degrees. Press and hold this button will make the vehicle keep drifting to the right-front at an angle of 45 degrees. Left slide 12. Left slide Press the Left Slide button to make the vehicle slide to the left. Press and hold this button will make the vehicle keep sliding to the left. 15. Program Press the Program button once, the vehicle beeps. You are now in the program entry mode. You can program the vehicle with the transmitter button of Forward, Backward, Turn left, Turn right, Nose drifts left, Nose drifts right, 45 left-front drifting, 45 right-front drifting, Left slide, Right slide, 45 left-rear drifting, 45 right-rear drifting, Tail drifts left, Tail drifts right, Body twist. Program up to 16 commands. After 16 commands, the vehicle will execute the commands automatically Press the Program button, the vehicle will execute your programmed selection.
/\ Warning CHOKING HAZARD Small Parts. Not for children under 3 years. Children should be supervised during play. Please keep this instruction manual for future reference, as it contains important information. FCC Statement WARNING: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This product uses the FCC Data API but is not endorsed or certified by the FCC