FCC ID: VJA-RJ1705 Radio Module with 5GHz WiFi

200 Chesterfield Parkway, Malvern PA 19355

(484) 595-0233 RJ1705, FCC IC Compliance Label, and Label Location RJ-1705 VIZMONET VJA-RJ1705 7382A-RJ1705 MODEL BRAND FCCID IC 25 mm 35 mm VIZMONET Model : RJ-1705 FCC ID : VJA-RJ1705 IC: 7382A-RJ1705

Rajant Corporation Declaration of the Modular Approval Applicant / Grantee Rajant Corporation VJA-RJ1705

|Model: | RJ-1705 The single module transmitter has been evaluated then tested meeting the requirements under Part 15C Section 2.12 as below:

Modular approval requirement EUT Condition

(a) The radio elements of the modular | Yes, EUT is meeting this requirement transmitter must have their own shielding. The physical crystal and tuning capacitors may be_ located external to the shielded radio elements. The modular transmitter must have buffered modulation/data inputs (if such Yes, The module buffers modulation and inputs using Network processor inputs are provided) to ensure that the system-on-chip. Kindly refer to the module will comply with part 15 | schematic diagram. requirements under conditions of excessive data rates or over-modulation.

(c) The modular transmitter must have its | Yes, the module uses Low Drop-out own power|supply regulation. regulator for power supply regulation. Kindly refer to the schematic diagram.

(d) The modular transmitter must comply | Yes, EUT is meeting this requirement with the antenna and_ transmission system requirements of Sections 15.203, 15.204(b) and 15.204(c). The antenna must either be permanently attached or employ a unique antenna coupler (at all connections between the module and the antenna, including the cable). The professional installation provision of Section 15.203 is not applicable to modules but can apply to limited modular approvals under paragraph (b) of this section.

(e) The modular transmitter must be tested | Yes, EUT is meeting this requirement in a stand-alone configuration, ie., the module must not be inside another device during testing for compliance with part 15 Rajant Corporation requirements. Unless _ the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in Section 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module

(see Section 15.27(a)). The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available (see Section 15.31(i)) must not be inside another device during testing.

(f) The modular transmitter must be equipped with either a permanently affixed label or must be capable of electronically displaying its FCC identification number. Yes, EUT is meeting this requirement The modular transmitter must comply Yes, EUT is meeting this requirement with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization requirements, which are based on the intended use/configurations. Yes, EUT is meeting this requirement

(h) The modular transmitter must comply with any applicable RF exposure requirements in its final configuration. Rajant Corporation Dated June 14, 2022 David Schena

| Signature Printed Name Title: VP Finance On behalf of: Rajant Corporation Telephone: 484-595-0233 Extension:220

5/9/2022 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: VJA-RJ1705 Pursuant to sections 0.457 and 0.459 of CFR 47, we respectfully request permanent confidential treatment of the following Exhibits accompanying this application as:

e.g. Block Diagram e.g. Schematics e.g. Operational Description e.g. Part List e.g. SDR software and security information The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, ilJJL_ Clients name & title: David Schena / VP Finance Telephone Number: 484-595-0233Extension:220 Fax Number: 484-595-0244 Email: dschena@rajant.com 200 Chesterfield Pkwy Malvern PA, 19355 5/9/2022 To: Federal Communications Commission Office of Engineering and Technology Equipment Authorization Division 7345 Oakland Mills Road Columbia, Maryland 21046 Subject: Short Term Confidentiality Request for FCC ID: VJA-RJ1705 To Whom It May Concern:

Pursuant to sections 0.457 and 0.459 of CFR 47, and to avoid premature release of sensitive information prior to marketing or release of the product to the public, the applicant requests the following documents contained in this certification application be temporarily withheld from public not to disclosure for an initial period of 45 exceed 180 days from the Grant Date. See KDB 726920. days; or for a specified date of or 180

The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors.

e.g. User Manual e.g. External Photos e.g. Internal Photos e.g. Test Setup photos Sincerely, Clients signature:

Clients name & title: David Schena / VP Finance Telephone Number: 484-595-0233Extension:220 Fax Number: 484-595-0244 Email: dschena@rajant.com 200 Chesterfield Pkwy Malvern PA, 19355

200 Chesterfield Parkway, Malvern, Pennsylvania 19355-3258, United States Date: 5/9/2022 UNII Device Declaration Letter To whom it may concern :

We have declared below featured for FCC equipment authorization, Device FCC ID : VJA-RJ1705

(1) DFS Device --

Master , Client without radar detection capability , Client with Radar detection capability , N/A

(2) Active / Passive Scanning , adhoc mode access point capability Frequency Band

(MHz) 5150~5250 5250~5350 5470~5725 5725~5850 Active Scanning

(the device can transmit a probe

(beacon)) Yes , Yes , Yes , Yes , Yes , Yes , Yes , No No No No No No No passive scanning

(where the device is can listen only with no probes) Yes , Yes , Yes , Yes , Yes , Yes , Yes , No No No No No No No Ad Hoc Mode capability Access point capability Yes , Yes , Yes , Yes , Yes , Yes , Yes , No No No No No No No X X X X Yes , Yes , Yes , Yes , Yes , Yes , Yes , No No No No No No No

(3) Country code selection ability -

Yes , No If no, pls explain how it was implemented :

(4) Meet 15.202 requirement -

Yes , No , pls check below :

A master device is defined as a device operating in a mode in which it has the capability to transmit without receiving an enabling signal. In this mode it is able to select a channel and initiate a network by sending enabling signals to other devices A client device is defined as a device operating in a mode in which the transmissions of the device are under control of the master. A device in client mode is not able to initiate a network.

(5) For client devices that have software configuration control to operate in different modes (active scanning in some and passive scanning in others) in different bands (devices with multiple equipment classes or those that operate on non-

DFS frequencies) or modular devices which configure the modes of operations through software, the application must provide software and operations description on how the software and / or hardware is implemented to ensure that proper operations modes can not be modified by end user or an installer. Apply , No Apply , (If apply , pls help to provide explanation on it was implement , and how software was controlled)

/Q_ Name & title: David Schena / VP Finance Telephone Number: 484-595-0233Extension:220 Fax Number: 484-595-0244 Email: dschena@rajant.com

Date: 5/9/2022 Declaration of Authorization We, Name:

Address:

City:

State:

Country:

Rajant Corporation 200 Chesterfield Parkway Malvern Pennsylvania United States Declare that, Agent Company name:

Address:

City:

Country:

A Test Lab Techno Corp. No. 140-1, Changan Street, Bade District, Taoyuan Taiwan Is authorized to apply for Certification of the following product(s) Product Name: Radio Module Model: RJ-1705 FCC ID : VJA-RJ1705 Trademark: VIZMONET on our behalf. Signature:

Place:

Name:

Title:

Malvern PA 19355 David Schena VP Finance This is valid until December 31, 2022, or until FCC certification are completed, whichever comes sooner.