G277/G577/G577h DECT Quick Reference Guide G577h G577 G277 Front View Side Views Package Contents:
- G277/577(h) DECT Handset
- Battery
- Belt Clip
- This Reference Guide
- Additional Information Sheet To use the G277/577(h) for the first time:
- Open the battery lid;
- Remove the plastic strip from the battery contacts
- Close the battery lid;
- Place the G277/577(h) on the charger to fully charge the battery G277/577 DECT Handset Quick Reference Guide 1 Main Menu Items Top Line Icons Contacts Central Directory Calls Settings Calendar Accessories Messaging (G577(h)) Signal Strength Battery Status Ringer Off Microphone Muted Keypad Locked Missed Call Voice Mail Present Indication GETTING STARTED Turning the G277/577(h) on and off Press and hold for a few seconds. Activating your phone When the display of your phone is dark, press any key to activate your phone (phone in Idle mode). Lock/Unlock your phone Press and then
(toggle function). Make a call and then type the number you want to reach. an then type the number you want to reach (speakerphone call) 1. Press 2. Press 3. Type the number you want to reach and then 4. Use a speed dial key (
or or
) OR OR OR OR 5. Press soft key or
, select the required contact and press soft key
,
, or
. Answering an incoming call Press End a call or, for speakerphone call,
. Press Make an enquiry call
. During a call, press toggle between the two parties. Press Change the volume to transfer the call. and dial the number of the party you want to consult. Press to During a call, press Volume Up or Volume Down on the side of the phone. The default volume level is 4. Use the Speaker phone During a call, press Mute the microphone during a call
; to de-activate: press again. Press the soft key
. To turn the microphone on again, press the soft key
. 2 G277/577 DECT Handset Quick Reference Guide Write and send a text message (G577(h)) In Idle mode, press
, use the navigation keys to select and press the soft key
. 1. Press soft key 2. Use the navigation keys to select a stored draft message and press soft key
, then enter the text of your message. OR
. Then press soft key
, select the type of the message (normal or urgent) and choose the required destination(s). When message sent is given in the display your message has been sent successfully. Assigning a contact to a speed dialling key In Idle mode, press soft key
, select the contact you want to assign a speed dialling key and press soft key
. Choose and press soft key
. Use the navigation keys to scroll to the appropriate number (2..9) and press soft key Register the handset
.
, use the navigation keys to select In Idle mode, press the navigation keys to select keys to select Enter the requested registration information (contact your System Administrator for this). Wait for the registration to be completed. Using the menu
(connectivity) and press soft key
(Register) and press soft key and press soft key
. Use
. Use the navigation to access the main menu. Use the navigation keys to go to the In Idle mode, press required menu, menu tab and menu item. Use soft key chosen menu or menu item/tab. Other soft keys may provide additional options. To go back one step in the menu or leave altogether, press
( or press
.
) to select the G277/577 DECT Handset Quick Reference Guide 3 Feedback Key Sound Confirmation Sound Coverage Warning Charger Warning Noise Reduction Display Wallpaper Startup Screen Power Save Charger Backlight Calls Units Answer Mode Caller Filter Emergency Call Number Message SOS Key (G577(h)) Voicemail Number Silent Charging Missed Call Time Connectivity Register Deregister Select Network Bluetooth (G577(h)) Enabled/Disabled Search for Devices Paired Devices 5. Calendar Manage your appointments 6. Accessories Alarms Calculator Stopwatch 7. Messaging (G577(h)) Drafts Inbox Sent Messages Settings Menu list 1. Contacts List of contacts 2. Central Directory Select required contact by name 3. Calls All Calls Answered Calls Dialled Calls Missed Calls 4. Settings General Settings Silent Time & Date Language
(Supported: English, Spanish, German, French, Italian, Dutch, Danish, Swedish, Turkish, Polish, Norwegian, Greek & Russian) Shortcuts (for the navigation keys) LED Signal Red LED Green LED Yellow LED Blue LED Security Phone Lock Automatic Key Lock Change PIN Proxy Password Handset Name Reset Settings Status Sounds Normal & Sounds Silent Incoming Call Ring Volume Ring External/Internal/Unkn own Group Ring Intercom Ring Emergency Ring Arb. Ring Increasing Ring Vibrator Message Notifications
(G577(h)) Notification Volume Notification Normal/Urgent/Emerg ency Increasing Notification Vibrator Alerts Alert Volume Alert Melody Increasing Alert Vibrator 4 G277/577 DECT Handset Quick Reference Guide device are performed in positions and location tests for each FCC Warning
(e.g. at the ear and worn on the body)as This device complies with part 15 of the FCC Rules. Operation is required by the FCC. For body worn operation, this subject to the following two conditions:
model device has been tested and meets the FCC RF
(1) This device may not cause harmful interference, and (2) this exposure guidelines when used with an accessory device must accept any interference designated for this product or when used with an received, including interference that may cause undesired accessory that contains no metal. operation. Any Changes or modifications not ISEDC Warning:
expressly approved by the party responsible for compliance This device complies with ISEDC licence-exempt RSS could void the user's authority to operate the standard(s). Operation is subject to the following two equipment. conditions:
Note: This equipment has been tested and found to comply
(1) this device may not cause interference, and with the limits for a Class B digital device,
(2) this device must accept any interference, including pursuant to part 15 of the FCC Rules. These limits are designed interference that may cause undesired operation of to provide reasonable protection against the device. harmful interference in a residential installation. This Le prsent appareil est conforme aux CNR d'ISEDC equipment generates, uses and can radiate radio applicables aux appareils radio exempts de frequency energy and, if not installed and used in accordance licence.L'exploitation est autorise aux deux conditions with the instructions, may cause harmful suivantes :
interference to radio communications. However, there is no
(1) l'appareil nedoit pas produire de brouillage, et guarantee that interference will not occur in a
(2) l'utilisateur de l'appareil doit accepter tout brouillage particular installation. If this equipment does cause harmful radiolectrique subi, mme si le brouillage est interference to radio or television reception, susceptible d'en compromettre le fonctionnement. which can be determined by turning the equipment off and on, The device has been tested and compliance with SAR limits, users can obtain Canadian information on RF the user is encouraged to try to correct the exposure and compliance interference by one or more of the following measures:
Le prsent appareil est conforme Aprs examen de ce Reorient or relocate the receiving antenna. matriel aux conformit aux limites DAS et/ou aux Increase the separation between the equipment and receiver. limites dintensit de champ RF, les utilisateurs peuvent Connect the equipment into an outlet on a circuit different sur lexposition aux radiofrquences et la from that to which the receiver is connected. conformit and compliance dacqurir Consult the dealer or an experienced radio/TV technician for help. ISEDC Specific Absorption Rate (SAR) information For Handset FCC Exposure to Radio Frequency (RF) Signals SAR tests are conducted using standard operating For Handset positions accepted by the ISEDC with device transmitting This is a radio transmitter and receiver. It is designed and at its highest certified power level in all tested frequency manufactured not to exceed the emission limitsfor bands, although the SAR is determined at the exposure to radio frequency (RF) energy set by the highest certified power level, the actual SAR level of the Federal Communications Commission (FCC) of the device while operating can be well below the U.S.Government. These limits are part of comprehensive maximum value. Before a new model device is a available guidelines and establish permitted levels of RF for sale to the public, it must be tested and energy for the general population. The guidelines are certified to the ISEDC that it does not exceed the exposure based on the safety standards previously set by both limit established by the ISEDC, tests for each U.S. and international standards bodies. These standards device are performed in positions and locations as include a substantial safety margin designed to required by the ISEDC. For body worn operation, this assure the safety of all persons,regardless of age and model device has been tested and meets the ISEDC RF health. This device and its antenna must not be colocated exposure guidelines when used with an accessory or operating in conjunction with any other antenna or designated for this product or when used with an transmitter. This product has been shown to be accessory that contains no metal. capable of compliance for localized specific absorption rate
(SAR) for uncontrolled environment/general population exposure limits specified in ANSI/IEEE Std. ISEDC Radiation Exposure Statement:
For Handset C95.1-1992 and had been tested in accordance with SAR lutilisation des rgles sma lemplacement Le matriel the measurement procedures specified in FCC/OET de transmission et fonctionnant dans tous les Bulletin 65 Supplement C (2001) and IEEE 1528. essais la certification, mme si la puissance suprme a dcid le niveau, utilisation spcifique peut tre trs en de de la valeur de rfrence maximale.Types de matriel sont vendus au public un ancien, dessai et de certification de lexposition, limite maximum sma, chaque document et lemplacement du matriel dessai et conformment au document.Le modle en physique, matriel dessai et conforme aux directives dexposition des radiofrquences sma quand une annexe dsign pour ce produit lors de leur utilisation ou des pices de rechange ne contiennent pas de mtal. FCC Specific Absorption Rate (SAR) information For Handset SAR tests are conducted using standard operating positions accepted by the FCC with device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. in general,the closer you are to a wireless base station antenna,the lower the power output. Before a new model device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC G277/577 DECT Handset Quick Reference Guide 5 CS03 Warning This product meets the applicable ISEDC technical specifications. / Le present matriel est conforme aux specifications techniques applicables dISEDC. The REN is an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. / Lindice dquivalence de la sonnerie (IES) sert indiquer le nombre maximal de terminaux qui peuvent tre raccords une interface tlphonique. La terminaison dune interface peut consister en une combinaison quelconque de dispositifs, la seule condition que la somme dindices dquivalence de la sonnerie de tous les dispositifs nexcde pas cinq. REN: NAN