FCC ID: 2AQZU-18047 CEILING FAN REMOTE CONTROL

DC POWER CEILING FAN REMOTE CONTROL MANUAL LEARNING PROCESS The Hand Held Remote Control is equipped with a learning ID function which has code combinations to prevent potential interference from other remote units. Install the batteries CR2032 3V*1 PC in transmitter. Within 30 seconds of turning the button and hold about 3 seconds, Receiver AC power ON, press the transmitter once the receiver has detected the ID, the receiver will make sound, Bi Bi Bi three times, This will indicate the receiver has learned the ID that was previously selected on the transmitter. Note: After the AC power is on, do not press any other buttons on the transmitter before learning ok. Because doing so will cause the procedure to fail. After completing the steps above, you should be able to operate the ceiling fan and light. If the ceiling fan is not responding to the transmitter, please turn the power off to the receiver and repeat LEARNING PROCESS Remove the batteries if not used for long periods of time to prevent damage to the hand held remote. The batteries must be removed from the transmitter before it is scrapped and the batteries shall be disposed of safety. Light function select switch:

FUCNCTIONS OF TRANSMITTER 1. 2. Turn off ceiling fan

: Setting up that the ceiling fan will turn on at 1~6 speeds 3.

: Setting forward/reverse airflow of ceiling fan. 4. Press and release immediately to turn on or off the light kit 5. after1, 2, 4 or 8 hours automatically. Setting up that the ceiling fan and light will turn off To assure continued FCC compliance:

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. CAUTION:

To assure continued FCC compliance:

Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. FCC ID2AQZU-18047 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Reference No.: WTH23X09200827W Page 1 of 10 ANNEX EXHIBIT 1 - PRODUCT LABELING Proposed FCC ID Label Format FCC ID: 2AQZU-18047 Specifications: The label shall be securely affixed to a permanently attached part of the device, in a location where it is visible or easily accessible to the user, and shall not be readily detachable. The label shall be sufficiently durable to remain fully legible and intact on the device in all normal conditions of use throughout the devices expected lifetime. Proposed Label Location on EUT FCC ID Label Location Waltek Testing Group (Shenzhen) Co., Ltd. Http://www.waltek.com.cn

Satellite Electronic(Zhong Shan)Ltd. No.8, Chuang Ye Road, Torch Development Zone, hongshan, Guangdong, China Date: 2023-09-05 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 USA Ref: Attestation Statements Part 2.911(d) (7) Filing Grantee Code: 2AQZU Applicant FRN: 0027796747 Satellite Electronic(Zhong Shan)Ltd. certifies that, as of the date of the filing of the application, Oriental Industries Group is our designated U.S. agent for service of process for the above referenced Grantee Code. Satellite Electronic(Zhong Shan)Ltd. accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Oriental Industries Group accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced Grantee Code. Designated U.S. Agent Information:

Name: Oriental Industries Group U.S. Agent FRN: 0033523226 Address: 1639 Clarks Lane SanchezJose, CA 95129 United States Contact Person: Mr Simon Kang Chen Tel.: (650) 433-6921 Email: simonkchen@gmail.com Sincerely, Signed on behalf of Satellite Electronic(Zhong Signed on behalf of Oriental Industries Group Shan)Ltd. Name: sean zheng Name: Simon Kang Chen Title: Manager Title: President Date: 2023-09-05 Date: 2023-09-05

Satellite Electronic(Zhong Shan)Ltd. Date: 2023-09-22 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements Part 2.911(d) (5) (i) Filing SUBJECT: FCC Application for FCC ID: 2AQZU-18047 To Whom It May Concern:

Satellite Electronic(Zhong Shan)Ltd. certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, fi f |

CCW". Dhorg

} y Signatory

[sean zheng, Manager]

Satellite Electronic(Zhong Shan)Ltd. Date: 2023-09-22 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Ref: Attestation Statements Part 2.911(d) (5) (ii) Filing SUBJECT: FCC Application for FCC ID: 2AQZU-18047 To Whom It May Concern:

Satellite Electronic(Zhong Shan)Ltd. certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List (as a specifically named entity or any of its subsidiaries or affiliates) as an entity producing covered equipment. Sincerely, Signatory

[sean zheng, Manager]

Satellite Electronic(Zhong Shan)Ltd. Date: 2023-09-22 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 SUBJECT: FCC Application for FCC ID: 2AQZU-18047 Confidentiality Request To whom it may concern, Pursuant to the provisions of the Commissions rules Title 47 Sections 0.457 and 0.459, we are requesting the Commission to withhold the following attachment(s) as confidential documents from public disclosure indefinitely. Xx! Block Diagram L] Tune-Up Information x] Operational Description L] Security Information XX] Schematics L] Software Defined Radio (SDR) Information L] Parts List The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. In additional to above mentioned documents, in order to comply with the marketing regulations in Title 47 CFR 2.803 and the importation rules in Title 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices, we request Short Term Confidentiality of the following attachment(s);

LC] External Photos L] Test Setup Photos L] Internal Photos [J User Manual LI For 45 days, pursuant to Public Notice DA 04-1705. or L] For 180 days pursuant to KDB 726920 D01. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Signatory

[sean zheng, Manager]

Satellite Electronic(Zhong Shan)Ltd. No.8, Chuang Ye Road, Torch Development Zone, hongshan, Guangdong, China Date: 2023-09-22 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 SUBJECT: FCC Application for FCC ID: 2AQZU-18047 POWER OF ATTORNEY To Whom It May Concern:

We, the undersigned, hereby authorize Waltek Testing Group (Shenzhen) Co., Ltd. Jandy So on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Waltek Testing Group (Shenzhen) Co., Ltd. Jandy So on our behalf shall have the same effect as acts of our own. This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, Satellite Electronic(Zhong Shan)Ltd. are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, eZ Signatory

[sean zheng, Manager]