2-WAY REMOTE STARTING SYSTEM WITH 1 BUTTONS FOR AUTOMATIC TRANSMISSION RED301-2WAY / ANT-2WDSS User Guide For Key This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. Using the remote control Description of Remote Appearance WARNING It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner. 1. When leaving the vehicle, it is the users responsibility to ensure that the gearshift lever is in Park in order to avoid accidents upon remote starting. (Note: Make sure that the automatic vehicle cannot start in Drive.) 2. It is the users responsibility to ensure that the remote starter is disabled or put into valet mode before servicing. FCC COMPLIANCE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this device. AVERTISSEMENT Il est de la responsabilit du conducteur de sassurer que son vhicule est stationn de faon scuritaire et responsable. 1. En quittant le vhicule, le conducteur doit sassurer que le levier de boite est la position P (stationnement) afin d'viter tout accident lord d'un dmarrage distance. (Note : Assurez-vous que le vhicule ne peut pas dmarrer alors que le levier de boite est la position D (Drive). 2. Il est de la responsabilit du conducteur de sassurer que le dmarrage distance est dsactiv ou que la tlcommande est en mode Valet lorsque son vhicule est au service mcanique. CONFORMIT FCC Ce dispositif est conforme larticle 15 de la rglementation du FCC. Le fonctionnement est assujetti aux deux conditions suivantes :
(1) Ce dispositif ne causera pas dinterfrences dommageables, et
(2) Ce dispositif doit pouvoir tre soumis toute interfrence, y compris des interfrences pouvant causer son mauvais fonctionnement. ATTENTION : Des changements ou modifications non approuvs expressment par la partie responsable de la conformit pourraient faire en sorte quil soit interdit par lutilisateur dutiliser ce dispositif. Using g the remote e control Descrip ption of Remot te Appearance Loc ck/Unlock No te: Press the button 1 time on the rem mote control transmit tter to lock the veh hicle. Press the butto on 2 times to unl ock the drivers doo r, 2 additional tim mes to unlock all door rs. Lock, Unlock a and Remote Starting icon is s displaying with r. One LED colo Lock, Unloc ck and Remote Starting icon Two LED co n is displaying with olor. START/STO P:
Note : Remo ote Engine Start -
Press the but tton 1 time and then, within 3 seco onds, press and hold the button for r 2 seconds 2Way Remote Remote Eng the button for gine Stop - Press r 2 seconds 1Way y Remote Button F Functions Bu utton Pre ess buttons for LED P Press 1time P Press 2 times ess 2times x 2 Pre 2 seconds ou make sure pres ss button only afte er LED lighting en Note: Yo Function Lock Unlo ock drivers door nlock all doors U Re emote start/stop ds to activate eac ch feature properly y. Vehicle Presets Heater When leaving the vehicle it is recommended to preset the accessory controls in preparation for the Next remote start. Settings for the blower motor(fan),front and rear (if equipped),should not be left on HIGH. It is recommended to leave the settings on LOW or MEDIUM instead. Windshield Wipers, Headlights Certain vehicles require the windshield wipers and headlights circuits to become energized while running under remote start. When leaving the vehicle you must ensure that the windshield wipers and headlights switches are OFF. Leaving the headlights switch ON on certain types of vehicles could cause them to remain ON even after remote starter shutdown, resulting in a dead battery. Leave Windshield Wipers off to avoid damage wipers/motor with remote start. Changing the Remote Control Transmitter Battery Remote transmitter should be provided with two 3-volt lithium battery (Model: CR-2025). Please pay attention that with low battery LED in the remote might not work and the remote start distance might get shorter. Batteries can be purchased at any electronic device stores. Following the instructions below to change the remote control battery 1. You may use a coin to pry the remote control halves apart 2. Remove the old battery and replace with a new one 3. Be sure to observe the (+) sign when inserting the new battery. 4. Before assembling transmitter case, you should test the remote control. D icon of 2way tra Note: LED ne ewly ansmitter indicates s firstly blue color r and then changee to RED color wwhen you press an ny button. In this ccase, its time to change CR2025 baattery ption of Anten nna Appearance e Descrip 2Way Antenna Antenna Harness se the power of the e antenna car bat ttery 12volts. Note: Us Starting your Ve Starting ehicle 2-way remote:
he KEY icon. onds later, the rem 1-way remote:
Remote-
Remote-
For the 2 display th 2. 5 seco For the 1 2. Remot If your ve system g Note: Ple Driving O te Stop - Press bu utton for 2 second s. ehicle does not sta ives up. 1. Press t the butto on one time. The r emote will beep o once and display t the Lock icon. The en, press the button within 2 seconds. The r remote will beep o once and mote will activate s starter. The Key ic con will be shown with 3 different to nes of beeping th hen the LED Icon w will be scrolled.. 1. Press button one time and Lock LE ED will be displaye ed. Then press button for 2 se econds within 3 se econds. art at the first attem mpt, the system w will shut down, wa ait a few seconds a and try to start the e engine again. Th here will be 3 star rt attempts before the ease make sure pr ress to button only y after LED lightin ng ends to activate e each feature pro operly. Off (Steps from R Remote Start to D Driving) With the v vehicle running re emotely, press button 2 time es to disarm the O OEM Starter Kill an nd/or the OEM ala arm and unlock th he doors. Enter the e vehicle and do t the he ignition key to t urn the key to the the IGNITION ON CRANK position N (RUN) position. while the engine following:
:
1. Turn th
(Do not tu brake) is running. This w would cause the st tarter motor to ree engage. Disarm th he remote starter mode by pressing g the foot o disengage the re the brake pedal to ady status to drive e. emote starter unit t. With the vehicle e key is in the IGN ITION ON positio on, press the brake e pedal or wait 30 0 seconds for the v vehicle to remote engine sta he door and 30 se rake pedal withou art status, engine w will be deactivate econds is passed. ON ON position. ut key is in IGNITI d according to fol lowing conditions
. Engine Your Re Note : R To chec Run Time emote Car Starte Run time is set b ck the amount of er can be program y installer. f runtime remaini ing (2-way only):
:
mmed to run the engine for 10 or r 5 minutes (10 m minutes by defau ult). After pr ressing bu tton once, if you u press but tton 2 times with hin 3 seconds, re emote starter wi ll be operated. O Once remote star rter is succeeded d and the engi ne is turned on, the remote will r receive signal an nd shows the rem maining remote s starter time as a START LED icon n. Starter Features Start Error Diagn nostic engine starter fai of Horn times nd the horn will so ound accordingly t to the table below w. ls, the vehicle wil l not be started an Remote St art Error n Hood open KEY IN or IG1 ON Valet mode e Brake pres ss Trunk open n Door open 2. Press t turn to re Note: In r
- Open th
- Press b Remote S Remote S If remote Number o 1 2 3 4 5 6 Valet/Ser For REM Valet/Ser When you engine fro Any of the Remote V rvice Mode MOTE Start KEY F rvice mode is used ur vehicle is in Va om being remote-
e following feature Valet:
This feature allow Fob d to prevent the s alet Mode, the rem
-started accidenta es will put your re ystem from unexp mote starter functio ally. emote car starter i nto Valet Mode :
ws you to put your r system into Valet t Mode by using t he transmitter. pectedly starting t onalities are disab the engine while b bled. If the vehicle being serviced. e needs to be serv viced, or if you pa rk it indoors, the V Valet Mode will pre event the To Engag 1) Insert t 2) Press ge Valet Mode/Ser the vehicles key t and hold the vehi rvice Mode: (Appr to the IGNITION, cle brake. roaching to Funct turn to the ON po tion stop mode) osition. 3) Press and hold the remo ote button fo or 2 seconds, the key LED will flash h and the vehicles s indicator will flas sh 1 time. Valet m ode is engaged. he system out of V the vehicles key t and hold the vehi Valet Mode (Retur to the IGNITION, cle brake. rn the system to it turn to the ON po ts normal operatin osition. ng mode): (Disarm ming Function Sto op Mode) 3) Press and hold the remo ote button fo or 2 seconds, the key LED will flash h and the vehicles s indicator will flas sh 2 times, Valet m mode is cancelled d. y whether the sys is in Valet mode, stem is in Valet M buzzer sounds s Mode using the 2 hortly when lock o 2-way remote:
or unlock button is s pressed. ed Features: Inst mote Car Starter w allation-program was designed with mmable Options flexibility and OE M integration in m mind. With its prog grammable option s, this unit can vir rtually control nea arly any electrical s system in To take th 1) Insert t 2) Press To verify If system Advance The Rem your vehi Caution:
cle. The programmin g of your system should be left to a a professional. Changing any one of the settings may affect the operation of your Remote Car Starter. Engine Run Time setting Option Setting Condition Disarm the vehicle with remote control transmitter.(Unlock) Driver s door must be physically Open, Engine Stop, Ignition ON, Trunk Open and Hood Open. Option Setting Instruction
- Under option setting condition, press button for 2 seconds. Light and Horn of vehicle will activate according to Engine Run Time option. Number of Indicator+ Horn 1 Time 2 Times Settings 10 Mins (Default) 5 Mins Light Blinking during remote engine start Option Setting Condition Disarm the vehicle with remote control transmitter.(Unlock) Driver s door must be physically Open, Engine Stop, Ignition ON, Trunk Open and Hood Open. Option Setting Instruction
- Under option setting condition, press button for 2 seconds. Light and Horn of vehicle will activate according to Light Blinking during remote engine start. Number of Indicator+ Horn 1 Time 2 Times Status Blink OFF (Default) Blick ON Pairing Remote Start Fob The Remote Start Fobs in Remote Start Kit are already paired with the main module at the time of production. There is no need to pair the Fobs at the time of the first installation. 1. When a new registration is needed
- When replacing a remote due to loss or malfunction of a remote. 5X X
- When re
- When a 2. Pairing 1) Open d 2) Insert t 3) After s 4) After re 5) Verify t
. NOTE:
1) A syste 2) If a new Troubles Many fac eplacing the main adding or changing controller installe g the remote upon ed in the vehicle. n users need. g procedure RS Fob X1 R 1 drivers door and the key into the ig tep 2), within 5 se egistering the 1st that all Fobs are f trunk. gnition. Turn the k econds, Press but Remote Start Fob functioning correc ey from OFF to O tton on the 1st Re b, within another 5 ctly by performing ON position 5 time emote Start Fob 1 5 seconds, Press Lock / Unlock fun s within 5 second time. button on the nex nction. s. xt 2nd Remote Sta art Fob 1 time. em can recognize w Fob, or addition e up to 3 remotes nal Fob, is needed maximum. d later, the Fob pa airing process sho ould be done with the original Fob o or oldest availablee Fob. shooting Poor Tr ctors may affect th ransmitting Rang he operating range ge e of the transmitte er. Some of these are:
-The condition of the batteries in the transmitter.
-The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers, etc).
-Metal in the area of the vehicle of transmitter. This includes the vehicle itself.
-The shape of the vehicle can affect range as well. Vans in general have greater interference. The shape of the roof and A-pillars causes considerable radio-frequency interference. Demonstrate to users that the best range is facing the vehicle's front. The worst range is facing the vehicles right or left side. Please inform the users that facing the vehicles front offers the best range. The worst range is experienced facing the R or L side.
-The amount of other vehicles in the area of the target vehicle.
-The method of using the transmitter. Always hold the transmitter high, approximately at shoulder height. Automatic Engine Start Repeat Remote Start is programmed to repeat the engine start sequence two (2) more times after ten (10) seconds if the engine start fails because of low vehicle battery.