SensorBlue Keychain Hygrometer User Guide Before using the product, here is 2 important points to keep the sensor accurate. Please follow the following steps to use the product. 1 . The sensor is an accurate humidity and temperature MEMS sensor. Please dont put it in the water. 2. The sensor detect the air temperature and humidity through the hole in the back, please dont cover it. 1. Please scan the QR code on the box or on the manual to download the APP. 2. 3. 4. Turn on the APP and make sure the Bluetooth of the APP is turned on. Take off the battery sleeves, then the sensor starts to work. Tape the Add device Or + to add the hygrometer. 5. The APP is going to pair the device. After you press the button on the product, it will connect automatically. Some models dont have the button, for those models, please tape Pairing by device name and then choose the Thermobecon Model NO.: WS07 Thanks for choosing SensorBlue WS07, The smart Bluetooth hygrometer thermometer. 6. Tape the camera icon to take photos for the place where you put the sensor. You can set up the desired alert temperature or humidity. When you connect the hygrometer with APP, you can read the instant temperature data and humidity data. 7. For some of the model which with the buzzer alert on device, if the tempera-
ture or humidity is out off range, it will have the alert on the device. If you need to check the graphic or history, tape the temperature number or humidity number directly. Then you will see them. Note:
After pairing your smart hygrometer with SensorBlue APP, you can use the APP to check the temperature and humidity. Technical Spec Temperature Range
-20~65C(-4~150F) Humidity range 0-100%RH Accuracy Temp: +-0.5C/1F Humidty: +-5.0%
Wireless Range Bluetooth 5.0 Free APP control Sensor Type Materials Battery Alarm Yes MEMS ABS 1*CR2032 NO History Memory Time Every 10 mins Battery life About 100 days Increase the separation between
-- Reorient or relocate the receiving antenna.
--
the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by for compliance could void the user's authority to operate the equipment. responsible the party This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any including interference that may cause undesired operation. interference received, Follow below steps to change the battery FCC Statement in a if not interference installed and used This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful residential installation. This equipment generates uses and can radiate radio frequency energy and, in accordance with the instructions, may cause harmful radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
interference to 1 . 2. 3. 4. 5. Clean your hands to make sure no water or oil. Hold key chain leather strap, pull it towards the earth. (like the attached picture). Push the battery out and replace a new CR2032 battery. Turn on the APP, and then press the key on the PCB board. You will see the led flash. After you see the temperature and humidity data appear again. Clip the plastic case back.