EN Wireless Remote Controller YK-11 Introduction Product Overview Test and Coding It can put into your pockets or purses or just be attached to your key ring. In case of emergency, press the [SOS] button, the alarm will be activated immediately. SOS 1 .L E D i n d ic a to r 2 .A r m 3 .D is a r m 4 .S ta y 5 . SOS 1 2 4 3 5 SOS 1 C Control Panel enters connecting state. ( For details, please refer to the relative user manual 2 Then press any key on the Remote controller. The control panel beeps once: the Remote controller is registered. If you hear two beeps, the Remote controller has already been connected. 1 2 3 Specifications Battery:
DC 3V(1*CR2032) Wireless standard:
433MHz Size:
69*36*11mm Quiescent current:
3UA Wireless distance:
70m(no obstacle) Alarm current:
15mA Working environment:
temperature -10 ~ +55 80%(no condensation) FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1)this device may not cause harmful interference, and 2)this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1)Reorient or relocate the receiving antenna. 2)Increase the separation between the equipment and receiver. 3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4)Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. 4 5 6 The version number: YK11T1-201911-V1.0 We reserve all the right of explanation of this user manual.