User Manual Products Name:Wireless RF 20 Keys LED Controller Model No:FC-L1B-R20Q Products Description:
Wireless RF 20 Keys RGB controller adopted the advanced computer control chip. Its mainly used to controlled all kinds of constant voltage led lights,such as:LED source, LED strips,led wall washer,wall Glass curtain lights,etc.It integrated with easy connection,simple manipulation and power off memory function.User can choose color jump, fade,fash mode ,and the lights brightness are adjustable according to the user actual requirement. Technical Parameters:
Working temperature-20-60 Input voltageDC12~24V Optional Output3 circuit Connection modeCommon anode or Cathode Controller sizeL102.5W65H30mm package sizeL135W80H54mm Net weight190g Function Model:14models. Static power consumption<1W Output current<4A/ch Output power 12V/4A < 144W24V/4A< 288W External Dimension:
Connecting Drawing:
Key Functions:
RRFF2200 KKeeyyss Key Function On/off Turn on/off Brightness+/-
Press this two keys to increase/decrease the brightness Static color mode key Can be choose the Static model fast by Speed up/down press these two keys to the key increase/decrease the changing speed AUTO Press this key to realize Dynamic mode FLASH White color strobe Press this key to realize 7 color strobe JUMP3 Dynamic mode key Press this key to realize 3 color jump JUMP7 Dynamic mode key Press this key to realize 7 color jump FADE3 Dynamic mode key Press this key to realize 3 color fade mode FADE7 Dynamic mode key FADE7 Dynamic mode key Direction for using:
1.Connect the load wire at first, following by the power wire; Please ensure short circuit can not occur between connecting wire before you turn on the power 2. Operation: you will receive remote control in front of receiver to ensure that there is no barrier between the remote controller and receiver. 3.The key-press functions are shown in the table as below (in accordance with the key position order):
Brightness +
Brightness -
pause ON/OFF Static red Static green Static blue Static white Static orange Static yellow Static Cyan Static purple Auto run Three color jump Three color Speed +
Flash Seven color jump Seven color Speed -
fade fade Common Problem and solution method:
Problems Possible cause Solution Lamp does not light after 1.Power cord is not properly connected, 1.Connect the power cord properly power or there is not output switching power or replay the power supply 2.Connected lighting power cord 2.Lamp power cord is not connected or short circuit 2. After connecting some The connected load is too largeso that it Replace parts of components or replace of the load the controller has burned in some of the components the controller does not work of the controller 3. After connecting to 1. The blank on the button cell of 1.Take away the transparent blank power the controller is remote controller did not pulled out 2.Target the remote controller to working properly but 2. the remote controller do not the receiver remote control can not target the receiver work FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.